7. WARNING « Failure to wear proper safety gear (i.e. eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools. « Improper operation of power tools may result in loss of control, serious injury or death. Always ensure you have complete control of the power tool and the work area is free of hazards before operation a power tool.
+ Door Height + is the distance between the finished floor and the horizontal line that you will pencil for the track. 2. Check if your floor is level. If not, please measure the distance from the highest point of your floor. Height 3. Make sure that the horizontal line has the same 2 length as your track length. So you can easily omm find your track hole center position to attach the 8) track to your wall in the following steps. 1.
Step-h Step-i 1. Drill a pilot hole all the way through the door using a “10mm” bit at the center that you had marked from Step-f Be careful and make it smooth. 2. Repeat on the above the other centers that you have marked. 1. Thread the hex bolt with the washer through the back of the door. 2. Hold hex bolt in place using a wrench and tighten your acorn nut by hand. 1. Using a wrench for the hex bolt and another wrench for the acorn nut, gently tighten, be careful not to damage your hanger or acorn nut. 2.
=u Step-1 1 d [TTT] 1. Guide your door to the resting position. 2. Use your level to plumb your door. 3. When the door is in the opening position, place the floor guide half way into the door slot. 4. Double check that your door is plumb. 5. Hold the door guide firmly in position and mark centers in the middle of both floor guide holes . 6. Use a “6mm” drill bit to drill 2 holes on the floor at the centers you have marked. 7. Put the plastic expansion nails into both of the holes. 8.
SLOPS Single door hardware kit Includes Part Name picture | 5FT b.5F1| oT oFTlr.
