Operating instructions

QUICKSTART

5.965-264.0 11/14

WARNING

These are only brief instructions! Please read the operating instructions accompanying the appliance

prior to using or maintaining the appliance.

The non-compliance with the operating and safety instructions may lead to damage of the

appliance and to risks for the operator and other persons.

Start up

A B C A Remove the cover of the wastewater tank.

B Remove waste water tank.

C Fill detergent solution into the fresh water

reservoir. The fill level must not exceed the

"MAX" mark.

Operation

A B C Turning on the Appliance

A Plug in the mains plug.

B Press the suction switch to turn on the

suction turbine.

C Press the spray switch to switch on the

spray pump.

A A Operate the lever on the manifold in

order to spray the cleaning solution.

Run across the surface to be cleaned in

overlapping paths. Pull the nozzle backwards

(do not push).

B Press the suction switch to turn on the

suction turbine.

C Press the spray switch to switch on the

spray pump.

Finish operation

A B Turn off the appliance

A Switch off the spray and suction switches.

B Pull out the mains plug.

Puzzi 10/1 - Puzzi 10/2

PAGE 1
QUICKSTART Puzzi 10/1 - Puzzi 10/2 -WARNING These are only brief instructions! Please read the operating instructions accompanying the appliance prior to using or maintaining the appliance. The non-compliance with the operating and safety instructions may lead to damage of the appliance and to risks for the operator and other persons. Start up 1 A B C A Remove the cover of the wastewater tank. B Remove waste water tank. C Fill detergent solution into the fresh water reservoir.
PAGE 2
QUICKSTART Finish operation 2 3 A B C Empty wastewater container A If the dirt water reservoir is full, switch off the suction and spray switches. B Remove the lid. C Remove the wastewater container from the appliance and drain it. A B C Empty the fresh water reservoir A Turn off the appliance. B Shortly activate the lever on bender to decrease the pressure. C Separate bender from the spray/suction hose. Insert the suction hose into the fresh water reservoir.