Instruction Sheet

ManualsBrandsJenn-Air ManualsAppliances4 piece Panel Ready Kitchen Appliances Package

INSTALLERS

TO AVOID DAMAGE TO RANGE

Door Removal

■ Do not remove the side door spacers until the range is ready to install. Removing the door spacers could allow the door to shift, damaging the door latch.

■ Do not lift or move the range by the door handle(s) or control panel.

■ Prior to installing the range, you will need to remove the oven door(s). Prepare a surface where you will place the door(s). This surface should be at and covered

with a soft blanket, or use the corner posts from the packaging material.

Replace the door

■ To replace the oven door(s), locate the slots in the oven cavity for the hinge locks and repeat the steps above in reverse order. Make sure the door closes properly

and there is no interference from the door latch. If necessary, remove the door and repeat the steps above. If power is connected to the range, open and close the

door to make sure the oven light comes on and goes off appropriately.

■ The range is equipped with leveling legs and rollers. Once the range is removed from the shipping pallet, make sure the leveling legs are not touching the oor and

use the rollers to move the range into position. Always cover the ooring surface to avoid damage to the oor. Do not roll the range directly on the oor.

■ Follow the installation instructions found in the bag containing the literature.

Door Transport & Strapping

■ Remove door(s) prior to moving the product with straps or appliance cart.

NOTE: Straps across the door could result in damage. Door must be removed in order to install kick plate.

■ Lift the product up and off the pallet.

NOTE: Tipping the range off the pallet may cause parts of the pallet to come into contact with the range and result in damage.

A. Oven door hinge in the

locked position

B. Oven door hinge in the

unlocked position

Partially close the door to engage

the door latch locks. The door will

stop at this point.

Use two hands to remove and replace

the oven door(s). It may be necessary

to gently shift door from side to side.

A. Slot in the oven frame for the

door hinge lock

WARNING

Excessive Weight Hazard

Use two or more people to move and install range.

Failure to do so can result in back or other injury.

W11266642A

Voir verso pour le français

Summary of content (2 pages)

PAGE 1
INSTALLERS TO AVOID DAMAGE TO RANGE Door Removal ■ Do not remove the side door spacers until the range is ready to install. Removing the door spacers could allow the door to shift, damaging the door latch. ■ Do not lift or move the range by the door handle(s) or control panel. ■ Prior to installing the range, you will need to remove the oven door(s). Prepare a surface where you will place the door(s).
PAGE 2
INSTALLATEURS POUR ÉVITER D’ENDOMMAGER LA CUISINIÈRE Retrait des portes ■ Ne pas retirer les cales d’espacement latérales de porte avant que la cuisinière ne soit prête pour l’installation. Si on retire les cales d’espacement de la porte, celle‑ci pourrait se déplacer et endommager le loquet de porte. ■ Ne pas soulever ou déplacer la cuisinière par les poignées de la porte ou le panneau de commande. ■ Avant d’installer la cuisinière, vous devrez retirer les portes du four.