Installation Guide

ManualsBrandsHusky ManualsCommercial Lighting7000 Lumens Portable Corded LED Work Light with Tripod

5 HUSKYTOOLS.COM

Please contact 1-888-HD-HUSKY for further assistance.

Installation

Assemble the work light

Release the tripod extension

lock

□ Press and hold the spring buckle (BB) on the

bracket and assemble the work light head (A)

to the work light body (B) in the direction

indicated by the arrow.

□

To deploy, release the tripod extension lock and

lift the light head upward until all three legs

release.

Open the tripod

Put the light on the ground

□ Shake the bracket to open the tripod.

□ Once all three legs are released, push the light

downward until all three legs make contact with

the ground.

same direction

Summary of content (4 pages)

PAGE 1
Installation 1 2 Assemble the work light □ Press and hold the spring buckle (BB) on the bracket and assemble the work light head (A) to the work light body (B) in the direction indicated by the arrow. Release the tripod extension lock □ To deploy, release the tripod extension lock and lift the light head upward until all three legs release. A same direction BB B 3 4 Open the tripod □ Shake the bracket to open the tripod.
PAGE 2
Installation (continued) 5 Lock the extension lock □ Once all three legs have made contact with the ground, lock it. To return the legs to the folded position for storage, release the extension lock and pull it back to the original position. NOTE: Ensure the worklight is not placed on a surface with greater than 8° slope. ＞8° 6 Raise the light head □ Release the top extension lock and raise the light head to the desired height, then lock the top extension lock.
PAGE 3
Installation (continued) 7 90° Adjust the light head □ Unfold the light head and adjust to the desired angle. 90° NOTE : If the light heads are either too loose or tight after adjustment, tighten the screw in the shaft as pictured with the wrench (AA) provided. ±165° ±165° AA 7 Store the wrench □ After using, store the wrench (AA) in the storage slot next to the light heads. AA 7 HUSKYTOOLS.COM Please contact 1-888-HD-HUSKY for further assistance.
PAGE 4
Installation (continued) 9 Plug the power cord into the outlet □ Place the power cord in the tripod slot as pictured and plug into the outlet. 10 Turn on the light □ Press the rocker switch.