Installation Instructions

8
1886
Installing the Glass
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote
Assembling the Light Kit
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Connect the plugs from the upper and lower switch
housings. Make sure to line up the colored markings
on the connectors. Align the keyhole slots in the light
kit housing with the two screws. Make sure all the
wires from the fan and the light kit are snug inside
the center of the light kit, not pinched in between the
upper switch housing and the light kit or hanging out
of the sides.
Turn the light kit counterclockwise until the
switch housing screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
1 of 3
BAG
2 of 3
Switch Housing
Screw
BAG
Switch Housing
Screw
Partially install two of the switch housing
screws found in the
bag. It does not
matter which two screw holes you choose.
Fan style may vary.
Note: