SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 207
Messages
SNACONTROL Error Messages
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNACIERR 27 MESSAGE: COULDN’T GET DIRECTORY INFO. (SNACIERR 27)
CAUSE: An internal error has occurred.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNACIERR 28 MESSAGE: THE LUNAME MUST BE SPECIFIED. (SNACIERR 28)
CAUSE: The
ROUTE , HSCB , or LURECORD parameter was specified in the
SNACONTROL STATUS command, but no
LUName parameter was specified.
ACTION: Reissue the SNACONTROL STATUS command with the
appropriate LUName parameter specified.
SNACIERR 29 MESSAGE: COULDN’T FIND LUNAME SPECIFIED. (SNACIERR 29)
CAUSE: The
LUName parameter specified in an SNACONTROL STATUS,
SNACONTROL STOPSESS, SNACONTROL TRACEOFF, or SNACONTROL
TRACEON command could not be found in the NMCONFIG.PUB.SYS
configuration file.
ACTION: Ensure that the
LUName is spelled correctly, and use NMMGR
or the configuration file critical summary to ensure that the LU is
actually configured.
SNACIERR 32 MESSAGE: COULDN’T GET AN NCB FOR THIS SNA NODE.
(SNACIERR 32)
CAUSE: An internal error has occurred.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNACIERR 33 MESSAGE: NO SUCH ACTIVE SESSION. (SNACIERR 33)
CAUSE: An
LUName for which no active session exists was specified in an
SNACONTROL STOPSESS or SNACONTROL TRACEOFF command.
ACTION: Issue the SNACONTROL STATUS command to see whether the
session for the specified
LUName exists. If it does, reissue the first
command. If the error still occurs, write down the circumstances and
call your Hewlett-Packard support contact.
SNACIERR 34 MESSAGE: CAN’T SPECIFY NODENAME HERE. (SNACIERR 34)
CAUSE: The NodeName parameter was specified in an SNACONTROL
VERSION command.
NodeName is not a valid parameter for that
command.
ACTION: Reissue the SNACONTROL VERSION command without a
NodeName parameter.