Read Before Installing MPE/iX Release 7.0 (C.70.00) (30216-90313)

12 Chapter1
Information You Need Before Installing MPE/iX 7.0
Modem Connections on A- and N-Class
If the parameters are not correct for the Remote Console Serial port, then answer “Y” to
the second prompt. Here is the full dialog to change the configuration, if needed:
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N])Y
Current Remote Console Serial Port Modem Protocol: CCITT
Do you want to modify it? (Y/[N]) y
Enter Modem Protocol (Bell / CCITT): c
New Modem Protocol: CCITT
Confirm? (Y/[N]): y
-> Modem Protocol will be updated.
Current Modem bit rate: 19200 bits/s
Do you want to modify it? (Y/[N]) y
Enter Modem bit rate (in bits/s): 19200
19200
New Modem bit rate: 19200 bits/s
Confirm? (Y/[N]): y
-> Modem bit rate will be updated.
Current Flow Control: Software
Do you want to modify it? (Y/[N]) y
Enter Flow Control (Hardware / Software): s
New Flow Control: Software
Confirm? (Y/[N]): y
-> Flow Control will be updated.
Transmit Configuration Strings: Enabled
Do you want to modify it? (Y/[N]) n
Modem Presence: always connected
Do you want to modify it? (Y/[N]) n
Command execution may take 25 seconds.
-> Settings have been updated.
GSP Host Name: <systemname>
GSP>
=====================================
Now enable the remote console: