HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 4 85
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
“CD-ROM Resources,” for directions on creating a Base Group.)
When ready to create the CSLT, HPINSTAL will
copy your current configuration group to HPCONFIG.SYS and use that
as the base group. If you have customized a configuration group
that you would like HPINSTAL to use as the base group while creating
the CSLT, please provide it now.
Base group (RETURN for default) >>
c. Proceed to Step 6.
6. If needed, edit or create a PRODLIST.PUB.SYS file.
A master product list was included with the CD-ROM. This list shows all products
available to be installed, and needs to be checked against your keyword certificate now.
a. Enter all numbers from the master list of products included with your keyword
certificate.
If your product list contains many of the over 200 subsystems, you can enter ALL as
your product number and then edit the list as necessary.
hpinstal can also automatically read the keyword for your products from the
KEYFILE.pub.sys file. (Refer to Appendix E , “CD-ROM Resources,” for directions on
creating and using the file KEYFILE.pub.sys.)
b. Add or delete product numbers as required.
NOTE Add-on product numbers can only be entered interactively.
c. When all product numbers have been entered, type two slashes (//) or
[Return].
7. Respond YES to accept the master list of products at the prompt.
Begin validation of the master product list...
Reading PRODLIST.PUB.SYS...
DONE
Your master list contains the following n subsystems:
[The subsystems included in the PRODLIST file are listed here.]
Is the master list of products correct (Y/N)?>
8. Type or verify the master product keyword at the prompt. Your keyword validates the
master product list.
The keyword is included on the keyword certificate that comes with the CD-ROM disks.
The keyword is not case sensitive. But you must enter it exactly as it appears including
the alphanumerics, slash (/), and hyphen (-).
If you have a keyfile.pub.sys file, hpinstal automatically reads the keyword for
your products from the keyfile.pub.sys file. (Refer to Appendix E , “CD-ROM
Resources,” for directions on creating and using the keyfile.pub.sys file.)
Please enter your keyword. The keyword accompanies the CD-ROM. It is made
up of fourteen (14) characters including alphanumerics, the slash(/) and
the hyphen (-). You must enter your keyword EXACTLY AS IT APPEARS: