HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

272 AppendixE
CD-ROM Resources
Adding a CD-ROM Drive
This program has the capability to identify the configuration of
the system and its I/O paths and devices. Many of the components
of the I/O system can be tested with selftest and loopback
diagnostics.
.
.
.
Do you wish to modify any program parameters? N
Record or print the I/O configuration table displayed on the screen.
This display shows all path names of the I/O components. These pathnames will be
needed later to add to the SYSGEN I/O configuration. This screen is a sample of an
IOMAP from an HP 3000 Series 950 system. The IOMAP display on your screen may
differ significantly from the one below.
Identify: Loop 1: All I/O components are being....
Processor Identification:
.
.
.
Type SW Rev Tests
Path Component Name ID Mod Hdwr Firm Avail
______ ___________________________ ___ ___ ___ ___ ___
8 A1700-50005 Channel Adapter 8H 5H 10H 0 0 ST LB
12 28640-60001-802.3-LAN 2H 4H 52H 0 0 ST LB
16 HP-PB SCSI Card 4H 4H 39H 0 0 ST LB
SCSI bus address for host adapter is 7
17 HP-PB Centronics Parallel Port 5H 4H 3AH 0 0
52 HP-PB SCSI Card 4H 14H 39H 0 0 ST LB
Resetting SCSI Bus (Approx. 10 seconds) ....
SCSI bus address for host adapter is 7
52.0.0 Unknown SCSI device type (C1533A )
52.6.0 HPC2474S disc drive - - - - 0B11 ST
56 A1703-60003 HP-PB Console/LAN Card 2H 14H 60H 0 0 ST LB
System Console is connected to this card
62 Native Processor 0H
63 Memory Controller (192 M bytes) 1H 14H 9H 0 0 LB
Slot 1A - 32M
Slot 1B - 32M
Slot 2A - 32M
Slot 2B - 32M
Slot 3A - 32M
Slot 3B - 32M
Identify Loop 1 (1H) complete
Respond YES to the prompt.
Do you want to exit this program and return to ISL? Y
IOMAP Exiting.
ISL>