HP XP P9000 Replication Manager Software 7.6.1-00 Application Agent CLI User Guide

Figure 67 System configuration for backing up a file system to tape and restoring it from tape
With Application Agent, file servers can be clustered. With file servers configured in a failover cluster,
if the active server fails, a standby server is available to take over operations from the active server.
This example assumes the following conditions:
• The system is equipped with a file server (server name: FSServer), and a backup server (server
name: BKServer) with a tape device connected to it.
• The primary volume and secondary volume are defined as a pair at the file server and the backup
server.
• The tape backup management software is installed on the backup server.
• The FTP server is running on the backup server, thus allowing the users who can log on to the OS
on each file server to log in the FTP server and transfer files to and from it. The FTP user ID must
be admin, and the FTP user password must be password.
• The parameter for the tape backup management software has been registered by using the
drmtapeinit command.
• The cscript //H:Cscript command is executed at the command prompt to modify the host
parameters.
• The primary volume paired with the secondary volume to be backed up is not backed up until the
backup of the secondary volume to tape is completed.
• The mount point E: exists on FSServer.
• The mount point to be backed up has been formatted by NTFS.
• The secondary volume is normally not mounted, but it is mounted on the E drive when it is needed.
• At each file server and the backup server, the storage directories for extended-command temporary
files specified in the operation definition file have been created.
Operation for file systems252