HP P9000 Replication Manager Software 7.2 User Guide

When the displayed information depends on the system configuration
In Replication Manager, displayed information might be limited by the system configuration. The
following describes such limitations separately for open systems and mainframe systems.
For open systems
In open systems, if a Device Manager agent is not installed on a host, the IP address and mount point
of the host cannot be obtained and therefore are not displayed.
In addition, if Device Manager servers at multiple sites remotely copy data between storage system
volumes that the servers manage, n/a is displayed because the following information cannot be
acquired if the storage system is XP512/XP48:
• LDEV number of a secondary volume
• Name of the storage system to which a secondary volume belongs
TIP:
It is assumed that each Device Manager server has been registered as an information source of
Replication Manager and that the pair management servers and hosts have been registered in the
Device Manager server at each site.
For a diagram, see “Example configuration in which data is remotely copied between multiple sites
(for open systems) ” on page 452.
For mainframe systems
In mainframe systems, if the storage systems connected to a host have been registered in a Device
Manager server, and that server has been registered as an information source of Replication Manager,
you can view detailed information about the storage systems.
However, if the connected storage systems have not been registered in a Device Manager server, or
if such a server has not been registered as an information source of Replication Manager, displayed
information is limited as follows.
Displayed informationInformation whose display is limited
This information is displayed as the family name of the storage system
(XP1024/XP128, XP12000/10000/SVS200, and XP24000/
20000).
Storage system name/type
The JNLGs Tab is not displayedJournal volume usage rate
No Object
Copy license information
In addition, if P9000 mainframe agent has been registered as an information source in a mainframe
system, you can only monitor copy pairs created using PPRC. Information displayed about the PPRC
copy pairs is limited as follows.
Displayed informationInformation whose display is limited
n/a
Name of the storage system to which the secondary volume belongs
User Guide 451