Hitachi Cache Manager User's Guide (HIT1642-96001, June 2007)

5-10 Return Codes, Output Messages, and Error Codes
Hitachi Cache Manager User’s Guide
Error
Number
Error Message Recommended Action
JSE511I-W
‘disk drive unit number’
IS NOT FOUND
The disk drive unit number specified by the dataset in RAIDPARM DD statement does not
exist.
(S) Terminate the process for this disk drive unit, but the process continues for the
following disk drive units. (Return code is 4.)
JSE800I-I command name ACCEPT The specified STATUS or COUNTS command has been accepted normally.
JSE801I-I END OF command name The specified STATUS or COUNTS command has been completed normally.
JSE802I-E
MISSING KEYWORD,
mandatory keyword
The mandatory keyword [STATUS, COUNTS, or VOLUME] is not specified.
JSE803I-I
OPERAND IGNORED,
operand name
An unnecessary operand is specified, but the process ignored the operand and continues.
JSE810I-E
DYNALLOC ERROR, dd
name, RETURN CODE
return code, ERROR
CODE X ‘error code’,
INFO CODE X ‘detail
code’
The following error happened during the operation of dd name dynamic allocation.
Return code: The return code of DYNALLOC macro (the contents of general register 15)
is indicated in decimal form.
Error code: The error code of DYNALLOC macro.
Detail code: The detail code of DYNALLOC macro.
(S) Terminate the command process.
(P) Examine the error code and correct the error, then execute the command again.
JSE811I-E SYSIN ALREADY USED The utility failed to allocate, because DD name SYSIN is in use.
(S) Terminate the command process.
(P) After releasing the allocation of DD name SYSIN, execute the command again.
JSE812I-E
I/O ERROR, dd name,
macro name
An error occurred during the file input/output operation of dd name.
(S) Terminate the command process.
(P) If another system has some messages, investigate the cause of the messages take
countermeasures if necessary, then execute the command again.