FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CE-TE, July 2004)

Configuring Zoning
199HA-Fabric Manager User Guide
Note: Only one appliance should be run at a time (actual appliances performing
discovery) or log on conflicts may occur.
8. Click OK.
Enabling or Disabling the Default Zone
Enabling the default zone enables the members that are not in zones to see all
other members that are not in zones.
1. Choose the fabric for which you want to enable the default zone.
2. Click Default Zone.
Note: Default zones are only supported in Homogeneous Fabric interop mode. It is
not supported in Open Fabric interop mode. If default zoning is not available, the
Default Zone button is disabled.
3. Click OK.
Deactivating a Zone Set
1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
Figure 101 on page 192.
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
all zoning actions.
3. Click the Zone Library tab.
4. Click Deactivate. The Deactivate Zone Set dialog box displays, as shown in
Figure 105.