FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

CLI Commands
118 CLI Reference Guide for Directors and Edge Switches
Syntax
deactivateZoneSet
Purpose
This command places all attached devices in the default zone if the default zone is
enabled and takes effect immediately for the entire fabric. If the default zone is not
enabled, there will be no zoning in effect and all attached devices will be unable to
communicate with any other attached device. This command clears both the active
zone set and the working area.
Description
The default zone must be activated independently of this command.
Note: This command takes effect immediately in the fabric.
Parameters
This command has no parameters.
Command Example
Root> config zoning deactiveZoneSet
config.zoning.deactivateZoneSet