HP Designjet H35000 and H45000 Printer Series - Unpacking and Assembly Instructions

ManualsBrandsHP ManualsPrinterHP Designjet H45100 EU Printer

HP Designjet 35000/45000 Printer series

Unpacking and Assembly Instructions

Connect cables

Switch on the power

Remove carriage restraints

Unpack

Remove shipping restraints

1. Cut the steel shipping bands from the shipping container.

2. Remove the lid and shipping box from the pallet.

3. Remove the packing material from around the outside of the

printer.

4. Locate the inks and the accessory kit box, on the shelf at the

right rear side of the printer. Remove and set aside.

5. Remove the starter media and set aside.

6. Using a ½-inch (13 mm) socket wrench, remove the four bolts

that attach the end plate to the pallet. Remove the end plate and

set aside.

7. Remove the pallet ramps from the pallet, and attach them as

shown using two of the bolts from the previous step.

8. Remove the bolts that attach the

printer to the pallet, and the bolts

that attach the L-shaped shipping

brackets to the printer (4 places).

9. Unlock the casters

(4 places).

10. Carefully roll

the printer

on its casters

off the pallet

and down

the ramps.

16 mm

13 mm

Bolt here

To power (220V AC)

Auxiliary power (24V DC)

(optional, see manual)

VideoNet to RIP

To optional foot switch

Power On/Standby switch

 Remove the bright colored tape from the media edge holders

(on the platen).

 Reach inside the left cover to cut the plastic restraining band

from the service station, and remove the band with attached

cardboard spacer.

 Cut the zip ties holding the light blocker at the front of the

platen, and lower it into operating position.

 Cut and remove zip ties and tape from the input and output

tables (rear and front of the printer), and from the adjustable

fence (rear of the printer).

 Cut and remove the shipping band that secures the service

station, and completely remove it from the printer.

Do not attempt to remove the carriage shipping restraints until

Step 5.



Press the power switch on the back of the printer to the On position.

The printer control panel will walk you through removing the shipping

restraints from the printhead carriage (see Step 5).

Ê With th loosen four

left and right

e included L-shaped hex key, the screws on

the arms, and pull the arms straight out from the

carriage.

Locate the cables in the accessory box, and connect as shown:

Continued on next page

Summary of content (2 pages)

PAGE 1
HP Designjet 35000/45000 Printer series Unpacking and Assembly Instructions 1 Unpack 1. Cut the steel shipping bands from the shipping container. 2. Remove the lid and shipping box from the pallet. 3. Remove the packing material from around the outside of the printer. 4. Locate the inks and the accessory kit box, on the shelf at the right rear side of the printer. Remove and set aside. 5. Remove the starter media and set aside. 6.
PAGE 2
5 Remove carriage restraints (continued) 7 Load roll-fed media Ë Remove the plastic spacers from the rail, behind the carriage (2 upper and 1 lower). 1. 2. 3. 4. 5. 6. Remove the media roll from its packaging. Load the media roll onto the supply spool. Load the supply spool onto the printer (unroll from the top of the spool). Unspool the media onto the platen. Press the Load Media key on the control panel. Follow the onscreen instructions.