Installation Guide

HINK L E Y LIGHTING 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
assembly instructions
Family: Parkside Item No. 2000
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then lamping the fixture.
start here
2000
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 2000 fixture is 100 watts bulb.
Drawing 2 - Glass Installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 1 - Fixture Mounting
A
J
B C D
E F
back plate
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the backplate (E).
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C).
5
10.22.10
1. It is recommended that the glass be installed prior to mounting fixture to wall.
2. To install glass, slip glass panel (1) into cage (A) through the bottom of the fixture
- see Drawing 2.
3. Slip glass into position flat against the inside of the cage.
4. Cut a small piece of sticky gasket material (3) and fix it to the glass above the glass
clip (2) - see Drawing 3.
5. Bend glass clips (2) so they engage the glass panel and gasket material to hold the
glass in place. Repeat for remaining panels. NOTE: When bending the glass clips
that are located on the sides of the cage bend one clip toward one piece of glass and
the other toward the adjacent glass.
1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1.
2. While holding fixture in place, thread the two ball knobs (F) on to the end of the
mounting screws (B), and tighten.
Drawing 3 - Detail Drawing
2
2
2
3
1
1
A
2
3