Operation Manual

48 Introduction and fundamentals

1.7 Fundamentals

Workpiece zero point

To machine a workpiece, it is easier to enter all input data with respect

to a zero point located on the workpiece. By programming the zero

point used in the workpiece drawing, you can take the dimensions

directly from the drawing, without further calculation. This point is the

workpiece zero point. It is designated with the letter "W" (see figure).

Units of measure

You can program the CNC PILOT either in the metric or inch system.

The units of measurement listed in the table below apply to all inputs

and displays.

Dimensions Metric Inches

Coordinates mm inch

Lengths mm inch

Angle Degrees Degrees

Spindle speed rpm rpm

Cutting speed m/min ft/min

Feed per revolution mm/rev inch/rev

Feed per minute mm/min inch/min

Acceleration m/s

ft/s