INSTRUCTION MANUAL 1 Light Track Pendant in Brushed Nickel Finish Home Depot SKU 720-879 (UPC 718212171004) (Brushed Nickel fixture) Track Construction: Hardwire Construction: LA-1599E/S/F Page 1
Thank you for purchasing this Hampton Bay Track Lighting. This product has been manufactured with the highest standards of safety and quality. FEATURES: 1. Traditional 1 Light Track Pendant in Brushed Nickel Finish. 2. Install as a Hardwire Mini Pendant or Track Pendant. 3. Easy to assemble and install. QUESTIONS, PROBLEMS, MISSING PARTS: Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 1 Canopy (#7) 3 Screw (#20) 1 Shade (#5) PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 1 Crossbar (#11) 2 Mounting Screw (#8) 2 Out Box Screw (#10) 1 Ground Screw (#12) 3 Wire Connector (#14) INSTALLATION INSTRUCTIONS: Track Construction: 1. Secure the Metal Tube (#4) to top of Socket Cup (#19). 2. Align the holes on the Shade (#5) and Socket Cup (#19), secure them with Screws (#20). 3.
Track Construction: Cont’ When installing or using this track system, basic safety precautions should always be followed, including the following: a.) Read all instructions. b.) Do not install this track in damp or wet locations. c.) (For track lighting systems other than those that comply with Section 31, Field Cutting) Do not cut any track sections. d.) Do not install any part of a track system less than 7 feet above the floor. e.
Hardwire Installation Instructions: 1. Secure the Metal Tube (#4) to top of Socket Cup (#19). 2. Align the holes on the Shade (#5) and Socket Cup (#19), secure them with Screws (#20). 3. Determine the length of wire needed for proper hanging height. Use a wire cutter to discard un-wanted wire. (Note: keep 2” additional length of wire for wire connection.) Carefully cut and remove approximately 2” of the outer sheathing from cord end and strip 3/8” of the wire ends bare to expose the copper strands.
TROUBLESHOOTING: Bulb will not light. Fuse blows or circuit breaker trips when light is turned on. Possible Cause 1. Bulb is burned out. 2. Power is off. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Faulty wire connection. 3. Check wiring. 4. Faulty switch. 4. Test or replace switch. Crossed wires or power wire Check wire connections. is grounding out. PRODUCT MAINTENANCE: 1.
