Assembly Instructions

Page 2 of 2

ASSEMBLY INSTRUCTIONS

Important Safety Instructions:

 For safety purpose, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does

not fit securely into your outlet, do not force it, contact a professional electrician. Never alter the plug in any way.

 These instructions are provided for your safety. It is very important that they are read carefully and completely

before assembling fixture.

 This fixture has been rated for up to (1) 40-watt maximum TYPE B bulb (no included) or (1) 10-watt compact

fluorescent light bulb (included). To avoid the risk of fire, do not exceed the recommended wattage.

Pre-assembly:

 Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or

hardware.

 Remove all parts and hardware from box along with any plastic protective packaging.

Parts Included: Hardware Included:

Caution:

 Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.

Warning:

 Wires and cables are all attached (further wiring is not needed from consumer). When unpacking product, be

careful to not pull wires as it may result as a bad connection. Do not plug into electrical outlet until lamp is fully

assembled.

Note:

Turn the power off (unplug from the wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to cool

down.

Assembly Instruction:

Item

Description

QTY

socket screws

Item

Description

QTY

metal cap

socket

glass shade

PAGE 1
ASSEMBLY INSTRUCTIONS Important Safety Instructions:  For safety purpose, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does not fit securely into your outlet, do not force it, contact a professional electrician. Never alter the plug in any way.  These instructions are provided for your safety. It is very important that they are read carefully and completely before assembling fixture.
PAGE 2
Step1. Unpack and place all parts on a surface or floor. Step2. Position the Glass Shade (C) onto the Socket (B), secure the Glass Shade (C) by rotating the socket screws (a) into the hole on the Metal Cap (A) clockwise by hand until tight. Do not over tighten. Step3. Screw the light bulb into the Socket (B). Step4. Assembly is completed.