Installation Guide

ManualsBrandsGeorge Kovacs ManualsBathroom & Wall LightingSilver Slice 4-Light Chrome Modern/Contemporary Vanity Light Bar

Fig 1

Set# A-020-170102

-mounting plate

-Ground Screw

-Mounting Screw*2

INSTALLATION

INSTRUCTIONS

FOR

P143

077

LED

oun

READ AND SAVE THESE INSTRUCTIONS

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off power at the fuse box or circuit breaker. Remove the

old fixture including the mounting hardware.

2. Carefully remove the fixture from the c arton and check that

all parts are included as show in Figure1. Unscrew screw(G) to

remove the mounting plate (A) from the canopy (F).

3. Position mounting plate (A) on t he wall, and mark the

location of two dry wall anchors (W). Pre-drill the holes for the

dry wall anchors. Insert the dry wall anchors (W) into the wall.

4. Attach the mounting plate (A) to the junction box using the

mounting screws (B, size 8#-32N 1"). The side of the mounting

plate marked “GND” must face out.

5. Place the wood screw (T) through the hole into the dry wall

anchor (W) to secure the mounting plate (A) as shown in Fig.1.

CONNECTING THE WIRES (Fig. 2)

6. Pass the black/white and bare copper wires from the

mounting plate (A). Connect the electrical wire as shown in

figure 2, making sure that all wire connectors are secured. lf

your junction box has a ground wire (green or bare copper),

connect the ground wire from the fixture to it. Otherwise connect

fixture ground wire directly to the mounting plate using the

green screw (D) provided. Tuck the wire connections neatly into

the wall junction box as you hold the canopy towards the wall.

FINISHING THE INSTALLATION (Fig.1)

7. Fix the canopy (F) into the mounting plate (A) with screw (G).

WARNING!SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU

Your installation is now complete. Return power to the junction

box and test the fixture.

CAUTION/ATTENTION: When handling the fixture, do not apply

pressure to the LEDs. Hold the fixture by the frame only.

IMPORTANT: Fixtures should be installed by a qualified

electrician t o ensure proper wiring and installation. Dimmable

with ELV and/or LED compatible wall dimmer switches.

Page 1/2

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR P1434-077-L For LED Wall Mount READ AND SAVE THESE INSTRUCTIONS WARNING!SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off power at the fuse box or circuit breaker. Remove the old fixture including the mounting hardware. 2. Carefully remove the fixture from the carton and check that all parts are included as show in Figure1.
PAGE 2
INSTALLATION INSTRUCTIONS FOR P1434-077-L For LED Wall Mount READ AND SAVE THESE INSTRUCTIONS WARNING!SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU LED module replace (Fig.3) Shut off power before replacing. 1. There have 2 LED modules in each head with this fixture, if one of them do not work, replace it as shown in Fig3. Make sure the power is off before you replace. 2.