Range Hood Control Panel Functions Manual

OPERATION

1. TWO BUTTON CONTROL PANEL

LIGHT - Switch A

Position 0: the light is off.

Position 1: the light is on.

SPEED - Switch B

This is used to start and set the speed of the motor, from 1 to 3, or with

continuous speed variator, depending on the version.

LIGHT - C

Motor operation indicator light.

2. FIVE BUTTON CONTROL PANEL

LIGHT- button

Pressed: the light is on

Released: the light is off

MOTOR button - 1, 2, 3, OFF

1: starts the motor at minimum speed

2: starts the motor at medium speed

3: starts the motor at maximum speed

OFF: stops the motor

3. ELECTRONIC CONTROL PANEL

Light pushbutton

• ON: light on (the pushbutton is lit);

• OFF: light off;

Pushbutton -

Press to reduce motor speed

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (exclud-

ing the light and the timer LEDs).

PAGE 1
G OPERATION 1. TWO BUTTON CONTROL PANEL LIGHT - Switch A Position 0: the light is off. Position 1: the light is on. SPEED - Switch B This is used to start and set the speed of the motor, from 1 to 3, or with continuous speed variator, depending on the version. LIGHT - C Motor operation indicator light. 2.
PAGE 2
Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). (In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set duration of time. After 15 minutes the motor returns to the third speed). Mode pushbutton Function: it turns hood motor on and off. The function “desired speed” enables to start the motor at the speed that was selected before the hood was last turned off.