Grill Assembly Built-In Instructions ........... Gas Requirements Leak Testing ................. Using 5-12 13-15 the Grill Rotisserie/Side Burner Usage ........... 16-19 Lighting the Grill ................. 17 Care & Maintenance 20 ............. Before You CaJm Trouble Visit the Frigidaire Web Site at: http ://www.frig idai re.corn READ AND SAVE THESE iNSTRUCTiONS Warranty Shooting ............. .......................... = MADE IN THE U.S.
i aS¸¸¸¸¸¸U /; Congratulations on your purchase of a new gas grill! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number We know you'll enjoy your new gas grill and Thank hope you consider us for future purchases.
IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme cam should be used because of the high temperatures produced by this appliance. CHILDREN UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. SHOULD NOT BE LEFT - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and flammable materials to come in contact with grate, burner or hot surfaces. liquids.
9 13 14 10 5 12 11 6 . Roll top grill hood 2. Grilling/Cooking 3. Side Shelf 4. Control . Warming shelf 9. Infrared 10. Electronic ignitor: & side burner 11. Cart w/doorr Control knobs: main burners 12. Ignitor access opening 6. Convection 13. Side Burner 7. ttandle 14. Control knob: Side Burner .
Cart Parts Part WIP- 192-71 D384 2 L-shaped 1 1 2 U-shaped back side piece Base Wheel channels Cart Door side pieces WIP- 192-72D384 WIP- 192-70D304 WIP- 192-438365L/R Parts 1 Door handle 1 1 Nylon kit RMP-122-00921 Grill Parts 1 1 Stainless Stainless 1 Side burner 1 Electronic 5 3 Flavor grids Stainless steel bar grates 1 1 Stainless steel warming Drip pan 1 Magnetic 1 Hose and regulator RMP-122-00520 bushing Door pivot screw Assembly #'s RMP- 122-00598/122-00508 an
Note: Prior to assembly remove protective film from stainless steel parts Fig. 1 Wheel Channel Fig. 2 Cart Assemblw 1. Door Stops & Door Pivot Bolts Attach the two L-shaped sides to the back portion of the cart, making sure the two holes face up & the key holes are on the top, using the (4) self tapping hex head screws. (See Fig. 1) Note: A power screwdriver is required to install the screws-be cautious not to over-tighten and strip the screws. Fig. 3 .
Attaching 1. Grill While Head keeping to Cart the Grill on the foam base lean it onto its back. hood shut when on its back, bottom . doing loosen this.) on the but do not Fig. 5 Fig. 5) Using 2 self, tapping hex head screws, attach the magnetic door catch in the 2 holes in the bottom of'the grill. (See Fig. 6) ttave someone help you pick up the grill and set it on the top of the cart, of" the grill above the door sure the 4 bolt heads opening bolts are resting Make the large slots.
Installing . the Cart Using a 5/32" through . Handles allen wrench the inside a bar handle (See Door insert 1 screw of the door front end and tighten into securely. Fig. 9) Insert Bar tlandle into the End Cap attached to the door and then into the Backside of door: 2 screw locations other End Cap and tighten End Cap with allen wrench and screw. (See Fig. 10) 3. Complete Door. (See. Fig. 11) Screw Holes Fig. 9 Installing .
Side Shelf Attachment Shelf . . Interior . Attach the shelf to the left side of grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with grill. (See Fig. 13) parts installation Check to make . sure the bottom around the ignitors, during shipment. Insert the second (See Fig. 14 are correctly cutouts . Fig. 13 Lock the shelf in place by inserting (2) self taping screws into shelf: (See Fig. 14) Grids .
. Attach the Side Burner inserting the shelf to the grill by hooks into the slots on the side of the grill and pushing assembly (See . until level on the shelf Fig. 19 Fig. 19) Lock the Side Burner (2) hex head screws of side burner. Note: down with the grill in place by re-inserting in the front (See & rear edge Fig. 20) A power screwdriver insert screw. extension is needed to Fig. 20 . Attach the Flex Line coming the grill to the fitting Side Burner. .
SIDE BURNER PARTS Install grate burner LEAK over ASSEMBLY (See Fig. 23) TESTING Make sure all burners are turned to "OFF". Turn on the gas at the cylinder (LP models) or main valve (Natural models). DO NOT turn on the side burner. Perform a leak test at all connections and fittings by spraying a 50/50 solution of water and soap. If any bubbles appear, correct the leak before attempting to light the grill or side burner. IGNITOR Fig. 23 ASSEMBLY 1.
Planning and Design Start by identifying the number and size of components you want to include: Grill, side burner, access doors for storage or other items you may wish to furnish such as: refrigerator, sink, warming drawer. Countertops must be constructed with non-combustible, outdoor-safe materials. Consider outdoor lighting to illuminate after-dark Grilling. For assistance in designing and building your outdoor cooking center, contact a landscape architect or general contractor.
GFI Electrical for rotisserie outlet c motor (6.5 amp rain.) Floor Support area for grill B f 35 V="Max.
General Information Verify the type of gas supply marking plate Note: Never For Natural on the back attach an unregulated Gas installations, All installer Electrical to be used, (located supplied Code, parts must sealants must on flare fittings. All gas connections and ordinances. Code, ANSI kits have the model testing This Grill must during be isolated codes, be made Propane (L.P).
L.P. Gas Frigidaire Installation Gas Grills assembly. (Note: replacement grill. Only use the pressure pressure to connect Attach that are set to operate directly assembly securely regulator and hose to a standard the gas hose Tighten regulator with L.R gas come and hose assemblies with a high capacity assembly specified hose and regulator supplied with the grill or a by Frigidaire). This assembly is designed 20 lb. L.P. cylinder.
General Information Although all gas connections tightness check excessive immediately Before must pressure on the grill are leaked be pertbrlned at the installation unknowingly check being if the smell tested applied at the factory prior site due to possible to the unit. Periodically to shipment, mishandling check a complete in shipment, the whole system gas or {'or leaks, or of gas is detected. Testing Do Not smoke while leak testing.
Grill Location Do not use the grill in garages, areas as this could a level surface. Note: The Clearance moving grill will operate to combustible Clearance and below construction of an outdoor removed from General Rules Do Not leave sheds monoxide best which - A minimum surface construction is required area. could Never result operate in injury the grill in enclosed or death. Place directly into the wind.
Before Lighting Warning: Check Important! the gas supply Always keep your face grill as possible Grill Burner Lighting when Before Lighting... line ibr cuts, wear and body or abrasion. as fhr away from the lighting. Lighting the Grill with electronic ignitor Always open the lid betbre attempting lighting. Push and turn one of the control knobs counter clockwise to the "ttlGH" position and immediately press the electronic ignitor button. You'll hear a snapping sound.
Using the Rotisserie (Optional ROTISSERIE & Side Burners KIT to use with Back Infrared Burner must be purchased separately) The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat is magnificent for searing in the natural juices and nutrients found in quality cuts of meats.
Rotisserie Open Lighting the lid. clockwise Then You'll Push and turn the control to the "ttlGtt" press position. Wait and hold the electronic ignitor hear a snapping light in 4 seconds, wait 5 minutes control knob knob sound. trying to the desired does is turned counter button. does not to OFF and Once setting. not function, a lit match knob again. lit, turn the (See Fig. 27) the burner to the burner clockwise counter 5 seconds.
Drip Tray The drip tray of debris. located Note: the drip tray to cool before Allow Cooking grates Wear a barbecue cleaning can be cleaned mitt and scrub the grates Stainless the cart, should attempting be cleaned periodically to prevent heavy buildup to clean. immediately the cooking will be easier after cooking grates if removed is completed with a damp cloth. and after turning If the grill is allowed from the grill and cleaned with a mild off the flame.
General Trouble You should The The The Shooting inspect the burners at least once a year or immediately if any of the following smell of gas in conjunction with the burner flames appearing yellow. Grill does not reach temperature. burners make a popping noise. conditions occur: The Grill heats unevenly. Before calling customer service If the Grill does not function properly, use the following checklist.
Problem Solution Check gas connection. Flame is erratic Fuel level may be low. Grill may be in need of cleaning. Check flavor grids and cooking excess build-up. Flare-Ups grates for Ensure Grill is not placed directly wind. in path of Be sure the drip tray is clean. (do not use aluminum foil in drip tray) Check the burner inlet for obstructions. Burner flame is yellow or orange, in conjunction with the odor of gas. Grill may be in a windy area. windy area if possible.
LIMITED Frigidaire Grills have a Lifetime LIFETIME Warranty and a 5 year warranty on all other IMPORTANT: We recommend be contacted The return warranty LIMITED on all stainless you return the warranty with any questions 15 years on stainless burners of the warranty registration of safety registration card so that you can arise that could affect card is not a condition you. tbr coverage.
