Accessory Installation Manual (2021, 2022)

Model PXCJA
920-119-02 (6-11)
2. Prepare the 265V (or 230V) power cord for
connection to the chassis’s power cord connector
by cutting the plug head to the appropriate length
(refer to Fig 2).
3. Route the cut end of power cord through the
locknut, spacers, conduit connector, bushing, and
flex conduit sleeve on the chassis’s junction box
(refer to Fig 3).
4. The lead cut end should pass all the way through
the opposite end of flex conduit sleeve into the
second bushing then between the elbow connector
housing. For wire protection, both bushing should
be inserted into the ends of the flex conduit sleeve.
Tighten the screws on elbow connector housing to
secure the conduit sleeve (refer to Fig 4).
5. Fasten and secure the elbow connector housing to
the wall junction box cover with locknut. Place and
mount wall junction box with all 4 mounting screws
making sure to pass the wall electrical lines through
the back opening of the junction box (refer to Fig 5).
Fig 2
Fig 3
Fig 4