Owner's manual

Installation

Eppendorf BioSpectrometer

basic

English (EN)

4.4.2 Thermal printer DPU-414

Connect the thermal printer DPU-414 to the serial printer connection.

1. Connect the printer cable to the serial printer connection 9 and tighten the locking screws.(see Main

illustration on p. 11).

2. Connect the printer cable to the printer and tighten the locking screws as well.

3. Connect the printer to the mains/power line using the supplied mains/power adaptor and mains/power

cord (printer accessory) and switch it on.

Information about modifying printer settings can be found in the operating manual for the printer.

The DIP switches are preset for the BioSpectrometer basic according to the following table.

Tab. 4-1: Setting the DIP SW for the thermal printer

DIP SW-1 Meaning

1 (OFF) Input = Serial

2 (ON) Printing Speed = High

3 (ON) Auto Loading = ON

4 (OFF) Auto LF = OFF

5 (ON) Setting Command = Enable

6 (OFF) Printing

7 (ON) Density

8 (ON) = 100%

DIP SW-2 Meaning

1 (ON) Printing Columns = 40

2 (ON) User Font Back-up = ON

3 (ON) Character Select = Normal

4 (ON) Zero = Normal

5 (ON) International

6 (ON) Character

7 (ON) Set

8 (OFF) = U.S.

DIP SW-3 Meaning

1 (ON) Data Length = 8 bits

2 (ON) Parity Setting = NO

3 (ON) Parity Condition = Odd

4 (OFF) Busy Control = XON/XOFF

5 (OFF) Baud

6 (ON) Rate

7 (ON) Select

8 (ON) = 9600 bps