™ Large ™ Owner’s Manual
800-342-8968 www.easystand.
Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . 2 Basic Unit Assembly-Evolv . . . . . . . . . . . . . . . . . 3 Configuration Assembly Glider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Shadow Support Tray . . . . . . . . . . . . . . . . . 9 Option Assembly . . . . . . . . . . . . . . . . . . . . . . . 11 Basic Unit Reference Drawing-Evolv . . . . . . . . .
Introduction Congratulations on your purchase of the Easystand Evolv standing frame! We at Altimate Medical have designed the EasyStand Evolv with your comfort and happiness in mind. This manual is an integral part of your standing system and should be read completely and thoroughly by anyone that will be operating the unit. This will ensure that the EasyStand Evolv is assembled properly and used in the most beneficial manner.
Safety Precautions • The EasyStand Evolv (Large) is designed to accommodate most individuals from 5’- 6'2" (152cm-188cm) and up to 280 lbs (127kg). If you do not meet these specifications and have not been properly fit by a qualified therapist or physician, Altimate Medical Inc. does not recommend that you use the EasyStand Evolv Large. • Altimate Medical Inc. recommends that you consult with your therapist or physician prior to starting a standing program.
® Basic Unit Assembly-EasyStand Evolv™ FIG. 5 Videos on EasyStand Evolv assembly & fitting can be viewed at www.easystand.com FIG. 3 FIG. 1 FIG. 2 FIG.
Front Column FIG. 2 Main Frame FIG. 1 FIG. 2 Note: Bolts are currently in proper location. FIG. 1- Attach the axle weldment to the front column with bolts and tighten securely. FIG. 2- Attach the casters to the rear of the base, lock the casters and hand tighten, do not overtighten. FIG. 3 Slide the front column into the opening of the main frame as shown. Install the four bolts into the holes. Do not tighten securely until all bolts are started. Flip down footplates and insert quick adjust handles.
FIG. 5 FIG. 6 FIG.
FIG. 5 FIG. 4 FIG. 4- Place kneepad onto knee bracket. Insert bolts and tighten securely. FIG. 5- Insert the tray post into the front column. Holes in the post must face upward. Place tray onto the tray post, insert nut into slot and tighten securely. FIG. 6 FIG. 6- Install the seat onto the main frame. For easier installation, pump the seat halfway up. Tighten the bolts securely. For Evolv adjustments, see page 23.
® Configuration Assembly- EasyStand Glider™ FIG. 8 FIG.
FIG. 7 FIG. 8 FIG. 7- Slide the front Glider column into the opening of the main frame as shown. Install the four bolts into the holes. Do not tighten securely until all bolts are started. FIG. 8- Slide the handles into the slots. Tighten securely. For Glider adjustments, see page 25.
Configuration Assembly® EasyStand Shadow Support Tray FIG. 9 FIG. 11 FIG. 9 FIG. 10 FIG. 13 FIG. 10 FIG. 15 FIG. 12 FIG. 14 FIG. 15 FIG.
FIG. 12 FIG. 13 FIG. 15 FIG. 14 FIG. 9- Attach the axle weldment to the front column with bolts and tighten securely. FIG. 10- Attach the casters to the rear of the base, lock the casters and hand tighten, do not overtighten. Slide the front column into the opening of the main frame as shown. Install the four bolts into the holes. Do not tighten securely until all bolts are started. Flip down footplates and insert quick adjust handles. Tighten securely. FIG. 11- Install the left table arm rest.
Option Assembly- Back Option Assembly Back Option Assembly page 11 Option Assembly
Contoured Backs High Contoured Back NG50068 Low Contoured Back NG50062 page 12 Option Assembly
Pump Handles Removable Actuator Handle NG50035 page 13 Option Assembly T-Style Handle Extension NG50070 Quad Grip Handle Extension NG50044
Foot Straps and Airline Buckle Hip Belt Secure Foot Straps NG30031 Standard Foot Straps NG30030 Airline Buckle Hip Belt NG30028 page 14 Option Assembly
Chest Vests and Chest Straps X-Style Chest Vest NG30056 Y-Style Chest Vest NG30021 Chest Strap NG50192-Small NG50193-Large page 15 Option Assembly
Angle Adjustable Tray, Chest Pad and Head Support Angle Adjustable Tray NG50043 not available w/the NG50024 Glider Chest Pad NG30000 not available w/the NG50024 Glider page 16 Option Assembly
Independent Knee and Roho® Seat Independent Knee NG50080 not available w/the NG50026 Glider Roho® Seat NG30023 page 17 Option Assembly
Universal Lateral Supports Receiver and Lateral Supports Universal Lateral Supports Receiver NG50041 Lateral Supports NG50176 page 18 Option Assembly
Hip Supports and Head Support Head Support NG50037 Hip Supports NG50198 page 19 Option Assembly
Basic Unit Reference Drawing® EasyStand Evolv™ page 20 Reference Drawing-Evolv
® EasyStand Evolv™ Options & Parts Detail page 21 Evolv Options & Parts Detail
page 22 Evolv Options & Parts Detail
® Adjusting Your EasyStand Evolv™ Footplates • FIG. A- Loosen the clamp connecting the foot bracket to the seat post. FIG. A • Adjust the height of the foot bracket so the user’s knee is as close to the knee pivot as possible. Caution: Avoid placing fingers in the adjustment slot. • FIG. B- The bracket can also be adjusted plantar/dorsi. FIG. B • Tighten the clamp securely. • FIG.
® Adjusting Your EasyStand Evolv™ Seat Depth/Back Angle • FIG. F- Loosen the two clamp knobs located on each of the seat tubes under the seat. FIG. F • Do NOT unscrew seat depth knobs all the way when adjusting the seat. • Depress the spring button and position the back such that the hip pivot is located as close as possible to the user’s hips. • Tighten the two clamp knobs. • Using the knob located on the following arm, adjust the back angle to vertical +/- 10 degrees.
Perfect Fit Guide Proper positioning is needed to obtain optimum standing posture. step one (A) (B) (C) (D) (E) (F) (G) (H) Measure client for approximate seat depth (A) and footplate (B) settings. step two To adjust seat depth, loosen the two ratchet handles under the seat (C). Depress the snap button on the adjustment tube while moving the back (D). Tighten the ratchet handles after adjusting.
® EasyStand Glider™ Adjustments FIG. C FIG. A FIG. B FIG. D FIG. A- To adjust the handle height, loosen the clamp. Adjust the handle height to the user’s desired position and tighten the clamp. FIG. B and C- To adjust the foot and knee height, loosen the two knobs shown in B. (For easier access to the inside knob, swing the leg assembly forward.) Adjust the foot height “FIG. B” and if necessary, the kneepad mounting position “FIG. C”, so that the user’s knee is centered on the kneepad.
® EasyStand Shadow Support Tray Adjustments Table Depth Adjustment Chest Pad Adjustment FIG. A FIG. A- To adjust the table depth, loosen the knob and lift slightly on the opposite side. Adjust to desired depth and tighten knob. To adjust chest pad height, loosen knob and move to desired position. Tighten securely. FIG. B- To flip the table up, move the table to the end of the tube and lift. Tighen knob securely. Caution: After flipping up the tray, be certain to tighten the knob.
Transferring & Standing Transferring • For proper transfer techniques, please seek professional advice from your therapist or physician. • The kneepad does not lock in the upright position when transferring, do NOT grab the kneepad for support. • Always lock the wheel locks on your wheelchair and the casters on the EasyStand Evolv before transferring. • If you do not need assistance in transferring, position your wheelchair next to the EasyStand Evolv.
Maintenance • Clean the EasyStand Evolv with a mild non-abrasive disinfectant or soap and water. • Check your EasyStand periodically to make sure that all nuts, bolts and adjustable parts are tightened securely. Hydraulic Actuator Maintenance • An initial break-in period of approximately 50-100 full cycles is normal for the hydraulic unit. You may experience a squeaking or a less-than-smooth forward stroke. The very close fit of its mating parts gives each pump its own break-in “feel” and signature sound.
® EasyStand Evolv™ Large Specifications Evolv- Basic Unit Height Range Weight Limit Seat Depth Range -from knee pivot to hip pivot -from knee pivot to back Seat to Footplate Range -from seat pivot Kneepad Depth Range -from seat pivot Seat Height Table/Frontpad Depth Range -from seat pivot Standard Table Height Range -from seat pivot Knee Width Large -center to center Footprint -caster to caster Weight of Basic Unit Frame Color Standard Upholstery Color Standard Table Size Evolv-Shadow Support Tray 5’0”-6
page 31 Standing Log
Limited Warranty This warranty is extended only to the original purchaser/customer (or supplier non consumer who does not buy or resell). Altimate Medical, Inc. (AMI) warrants the EasyStand Evolv Large against defects in materials and workmanship as listed below.
P.O. Box 180 262 West 1st St Morton, MN 56270 Toll Free: 800.342.8968 or 507.697.6393 Fax Free: 877.342.8968 or 507.697.6900 email: info@easystand.com www.easystand.com ™ Standing technology should only be used under the guidance of a physician with recommendations for standing program protocol and any medical precautions. Standing programs should be monitored by the attending therapist.
