(PUD2 and PUDOF2)
Installation Instructions 3 2 1 Note: These instructions are for both the standard pop-up drain and over-flow pop-up drain. Step 1: Remove the mounting nut (1), washer (2) and gasket 2 (3) from the pop-up drain. 1 2 Step 2: Ensure that gasket 1 (1) is under the flange (2) of the pop-up drain, then insert the body of the drain into the sink drain hole.
Installation Instructions 1 Step 3: Install gasket 2 (1) onto the drain body and be sure that the flat side of the gasket is facing down. 1 3 2 Step 4: Install the washer (1) and mounting nut (2) on the drain body and securely tighten the mounting nut to ensure that gasket 2 (3) is secure and even. Check drain flange in sink to ensure that gasket 1 is fully compressed and not visible.
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.