User Manual

5. Wait for the firmware to download. The firmware update will start automatically.
6. The aircraft will reboot automatically after the firmware update is complete.
Follow the instructions below to update the remote controller firmware through DJI Assistant 2
(Consumer Drones Series):
1. Launch DJI Assistant 2 (Consumer Drones Series) and log in with your DJI account.
2. Power on the remote controller and connect to a computer via the USB-C port using a Micro
USB cable.
3. Select DJI Air 2S Remote Controller and click on Firmware Updates on the left panel.
4. Select the firmware version that you wish to update to.
5. Wait for the firmware to download. The firmware update will start automatically.
6. Wait for the firmware update to be completed.
Make sure follow all the steps to update firmware. Otherwise, the update may fail.
The firmware update will take approximately 10 minutes. It is normal that the gimbal
goes limp, aircraft status indicators blink, and the aircraft reboots. Wait patiently until
the update is complete.
Make sure the computer has access to the internet.
Before performing an update, make sure the Intelligent Flight Battery is at least 40%
charged and the remote controller is at least 30% charged.
Do not disconnect the aircraft from the computer during an update.
After-sales information
Visit https://www.dji.com/support to learn more about after-sales service policies, repair services,
and support.