Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking OS.
If there is a change in the running conguration, the system prompts you to save the new conguration when you
reload the system using the reload command. You can also save your running conguration manually using the
copy running-config command.
You can use the conditional parameter if any conguration changes made to the NVRAM, such as, stack-
group and fanout congurations, must be saved.
Example
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
Dell#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter the install mode directly:
Dell#reload onie install
Proceed with reload [confirm yes/no]: yes
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Control and Monitoring 123