Users Guide
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
debug ip igmp
Enable debugging of IGMP packets.
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
• To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name] [group address |
interface] command.
• To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
debugging of IGMP packets corresponding to that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
Internet Group Management Protocol (IGMP) 577