Users Guide

If the next hop address is reachable, trac is forwarded to the specied next hop. Otherwise, the normal routing
table is used to forward trac. When a redirect-group is applied to an interface and the next-hop is reachable, the
rules are added into the PBR CAM region. When incoming trac hits an entry in the CAM, the trac is redirected
to the corresponding next-hop IP address specied in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related Commands
• show cam pbr – display the content of the PBR CAM.
• show ip redirect-list – display the redirect-list conguration.
ip redirect-list
Congure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
6.5.3.0 Introduced on the E-Series.
Policy-based Routing (PBR) 1109