Users Guide

• The grace-timer remaining value for each interface
• The packet count received and transmitted for each neighbor
• Dead timer remaining value for each neighbor
• Transmit timer remaining value for each neighbor
• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Example (Statistics)
Dell(conf-if-gi-1/6)# do show ip ospf statistics
Interface GigabitEthernet 1/6
Error packets (Receive statistics)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unknown-Pkt 0 Bad-LsReq 0
RtidZero 0
Neighbor ID 4.4.4.4
Packet Statistics
Hello DDiscr LSReq LSUpd LSAck
RX 5 2 1 3 2
TX 6 5 1 3 3
Timers
Hello 0 Wait 0 Grace 0
Dead 39 Transmit 4
Queue Statistics
LSU-Q-Len 0 LSU-Q-Wmark 1
LSR-Q-Len 0 LSR-Q-Wmark 1
Dell(conf-if-gi-1/6)#
Related Commands
• clear ip ospf statistics — clear the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
Syntax
show ip ospf [process-id] timers rate-limit
Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
1068 Open Shortest Path First (OSPFv2 and OSPFv3)