Setup Guide
NOTE: If you apply the redirect-list to an interface, the output of the show ip redirect-list redirect-list-
name command displays reachability status for the specied next-hop.
Example: Showing CAM PBR Conguration
DellEMC#show cam pbr stack-unit 1 port-set 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress
Index Flag Port Port MAC Port
---------------------------------------------------------------------------------------------
--------------------
06080 0 N/A IP 0x0 0 0 200.200.200.200 200.200.200.200 199.199.199.199
199.199.199.199 N/A NA
06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234 222.222.222.222/24
00:00:00:00:00:09 8/1
Sample Conguration
You can use the following example conguration to set up a PBR. These are not comprehensive directions but are intended to give you a
guidance with typical congurations. You can copy and paste from these examples to your CLI. Make the necessary changes to support
your own IP addresses, interfaces, names, and so on.
The Redirect-List GOLD dened in this example creates the following rules:
• description Route Gold trac to the DS3
• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any trac originating in 192.168.1.0/24”
• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any trac originating in 192.168.2.0/24”
• seq 15 permit ip any
Policy-based Routing (PBR)
633