Setup Guide

TX - Debug Counter 7 0
TX - Debug Counter 8 0
TX - Debug Counter 9 0
TX - Debug Counter 10 0
TX - Debug Counter 11 0
TX - EEE LPI Event Counter 0
TX - EEE LPI Duration Counter 0
<<Output Truncated>>
Clear EEE Counters
To clear the EEE counters, use the following the commands.
• Clear the EEE counters on all the copper ports.
EXEC Privilege mode
clear counters eee
• Clear the EEE counters on the specied port.
EXEC Privilege mode
clear counters interface-type slot/port eee
• Clear the EEE counters on the specied range of ports.
EXEC Privilege mode
clear counters interface-type slot/port-range eee
Examples of the clear counters eee Command
When you use this command, conrm that you want Dell EMC Networking OS to clear the EEE counters.
DellEMC# clear counters eee
Clear eee counters on all Copper Ports [confirm] y
DellEMC#
DellEMC# clear counters gigabitethernet 1/1 eee
Clear eee counters on Gi 1/1 [confirm] y
DellEMC#
DellEMC# clear counters gigabitethernet 1/1-10 eee
Clear eee counters on Gi 1/1-10 [confirm] y
DellEMC#
Physical Interfaces
The Management Ethernet interface is a single RJ-45 Fast Ethernet port on a switch.
The interface provides dedicated management access to the system.
Stack-unit interfaces support Layer 2 and Layer 3 trac over the 1-Gigabit Ethernet and 10-Gigabit Ethernet. interfaces. These interfaces
can also become part of virtual interfaces such as virtual local area networks (VLANs) or port channels.
For more information about VLANs, refer to Bulk Conguration. For more information on port channels, refer to Port Channel Interfaces.
Dell EMC Networking OS Behavior: The system uses a single MAC address for all physical interfaces.
Conguration Task List for Physical Interfaces
By default, all interfaces are operationally disabled and trac does not pass through them.
The following section includes information about optional congurations for physical interfaces:
Interfaces
357