2 Channel/4 Channel Video Multiplexer USER’S MANUAL 7030 and 7040 Series WORLD HEADQUARTERS 55 Cabot Court Hauppauge, N.Y. 11788 USA Tel: (631) 273-0404 Fax: (631) 273-1638 www.commspecial.com Email: info@commspecial.com Communications Specialties Pte Ltd 100 Beach Road #22-09 Shaw Tower Singapore 189702 Tel: +65 6391 8790 Fax: +65 6396 0138 Email: csiasia@commspecial.com P/N: 122051 Rev.
in material and workmanship under normal use and service. A Return Material Authorization (RMA) number must be obtained from CSI at the expense and risk of the Buyer. CSI’s Obligation under this warranty will be limited, at its option, to either the repair or replacement of defective units, including free materials and labor. In no event shall CSI be responsible for any incidental or consequential damages or loss of profits or goodwill.
GENERAL INFORMATION Introduction The Pure Digital Fiberlink® 7030 and 7040 Series transmit multiple channels of uncompressed composite video over a single fiber optic cable. The 7030 Series (2 channels video) and 7040 Series (4 channels video) provide 7 MHz bandwidth per video channel and are compatible with NTSC, PAL and SECAM video standards. Systems are offered for use with single mode or multimode fiber.
RECEIVER: Video: OFF: Indicates no video detected over fiber and, as a result, no video present on output BNC ON: Indicates video detected over fiber and, as a result, video present on output BNC Alarm: ON: Loss of input video or optical signal (rack card only) OPERATING POINTERS AND TROUBLESHOOTING Optical Fiber: The 7030 and 7040 Series are available in versions that operate with most multimode (MM) and single mode (SM) optical fibers.
INSTALLATION INSTRUCTIONS Alarm Switch Settings (Receiver; Card Version Only) Installation Procedure The Pure Digital Fiberlink 7030 and 7040 Series transmission systems are normally preset for immediate use. There are indicator LEDs on the units for monitoring purposes. The following instructions describe the typical installation procedure and the function of the LED indicators. 1. Connect the fiber optic cable or cables between the two Pure Digital Fiberlink units. 2.
INSTALLATION INSTRUCTIONS Alarm Switch Settings (Receiver; Card Version Only) Installation Procedure The Pure Digital Fiberlink 7030 and 7040 Series transmission systems are normally preset for immediate use. There are indicator LEDs on the units for monitoring purposes. The following instructions describe the typical installation procedure and the function of the LED indicators. 1. Connect the fiber optic cable or cables between the two Pure Digital Fiberlink units. 2.
RECEIVER: Video: OFF: Indicates no video detected over fiber and, as a result, no video present on output BNC ON: Indicates video detected over fiber and, as a result, video present on output BNC Alarm: ON: Loss of input video or optical signal (rack card only) OPERATING POINTERS AND TROUBLESHOOTING Optical Fiber: The 7030 and 7040 Series are available in versions that operate with most multimode (MM) and single mode (SM) optical fibers.
GENERAL INFORMATION Introduction The Pure Digital Fiberlink® 7030 and 7040 Series transmit multiple channels of uncompressed composite video over a single fiber optic cable. The 7030 Series (2 channels video) and 7040 Series (4 channels video) provide 7 MHz bandwidth per video channel and are compatible with NTSC, PAL and SECAM video standards. Systems are offered for use with single mode or multimode fiber.
in material and workmanship under normal use and service. A Return Material Authorization (RMA) number must be obtained from CSI at the expense and risk of the Buyer. CSI’s Obligation under this warranty will be limited, at its option, to either the repair or replacement of defective units, including free materials and labor. In no event shall CSI be responsible for any incidental or consequential damages or loss of profits or goodwill.
