Installation Instructions

35
Reversing Door Lock
NOTE: The lock mechanism is factory-installed in
the active panel. If you have reversed the
panel, the lock must also be reversed.
1. Locate the lock slot, which is visible through one
of the large handle holes. Use a slotted screwdriver to
turn the lock slot until the latch hook is fully
extended (FIGURE 1).
2. Use a Phillips screwdriver to remove the top lock
installation screw.
3. Grasp latch hook firmly with your fingers and
remove second installation screw.
4. Continue holding latch hook securely and push
lock mechanism slightly inward, then upward, until
bottom of lock clears the lock opening.
5. Pull bottom end of lock out of opening and remove
lock (FIGURE 2).
6. Turn lock around so latch hook faces upward
(FIGURE 2).
7. Hold latch hook and insert top of lock into opening
(FIGURE 2).
8. Slide lock into place, aligning the lock screw holes
with holes in the vinyl sash.
9. Fasten with installation screws.
10. Install active panel in door frame following
procedure on Page 18.
4
1
2
3
Bottom Lock
Installation Screw
Mechanism
Latch
Hook
Top
Lock
Installation
Screw
Lock
Slot
Holes
Lock
Handle
Lock
FIGURE 1
Remove
Replace
FIGURE 2