User Manual

Congratulations on the purchase of your new SaluSpa™. Before
operating the SaluSpa™ be sure to follow these 13 steps.
Damage resulting from misuse is not covered by the
manufacturer's warranty.
1
S-S-005326
Be sure to set your desired
temperature.
1
The SaluSpa™ should not be
setup or left out in
temperatures lower than 4˚C
(40˚F).
MAX
MIN
Fill the water level between
maximum and minimum printed
on the SPA wall.
Water
Level
3
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
4
Check and ensure the Spa and all
adapters are not leaking.
6
5
Hibernate Function:
After 72 hours of operation (except timer
function),
the pump will hibernate and “End”
will be display on the LED. When the pump is
hibernating both the rapid heating and water
filtration functions are disabled. To re-active
the pump simply press any button on the
control panel.
10
9
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
Change the Filter Cartridges
regularly
8
Clean and maintain the Filter
Cartridge regularly.
7
13
IMPORTANT NOTICE:
This unit will auto lockout after
5 minutes of inactivity.
To simply place a finger
over function button
for 3 seconds.
11
We recommend you take a shower before
using your Spa, as cosmetic products,
lotions, and other residues on the skin
can quickly degrade water quality.
12
The GFCI plug must be tested before
each use to avoid risk of electric
shock. Do not use the pump
if this test fails.
2
RESET
™