User's Manual

This device has two ways to turn power on and
off. Hardware ON/OFF Slide the switch to ON or
OFF position. If the slide switch is OFF, you
cannot use the software switch to turn on the
power. If the unit is not in use for a long period,
use the hardware switch to turn off the unit.
This allows the transmitter to be controlled
externally. If the sensor is ON, press and hold
the software ON/OFF switch 5 seconds, the LED
will flash once, sensor is “OFF”. If the sensor is
OFF, press and hold the software ON/OFF switch
5 seconds, the LED will flash three times, sensor
is ‘ON’. The sound sensor defaults to "ON" when
the hardware switch is moved from OFF to ON.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the F C C Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
* Reorient or relocate the receiving antenn a .
* Increase the separation between the equipment and receiv e r .
* Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FC C rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: Modifications to this product will void the user's authority to
operate this equipment.
DIP
Switch
ON/OFF button
Sensitivity
Power On/OFF
Battery
compartment
Battery Installation
Setting
+
+
Insert 2 AAA battery compartment
Hardware switch
Software switch
FCC Statement:
CAUTION
USER MANUAL
AMDX
Turn O N and turn O F F the device
Software ON/O F F
1 2 3 4
O N
The DIP switch is
inside the top cover.
RI S K OF EXPL O S I ON IF BATT ERY IS RE P L A C ED BY AN
I N C O R R E C T T Y P E D I S P O S E O F U S E D B A T T E R I E S
AC COR DING TO THE IN STRU CTI ONS
Use a pen or pencil to set the switches to match the switches
in AL10