User Manual

17-2

Flow from py File Creation to Running the File k

The example below explains the operation flow from creation of a new py file up to running it.

Example: To create a py file that obtains the surface area and volume of a regular

octahedron and to run it to calculate the surface area and volume when

the length of one side is 10. The file name is OCTA.

You can obtain the surface area (S) and volume (V) of a regular octahedron

when the length of one side (A) is known using the formulas below.

S = 2'3 A

, V = A

––––

Here we will write a program that, when the py file is run,

prompts for input of A, which is then used in the above

formulas to output the calculation results. In this manual, a

program written in Python (and stored in a py file) is called a

“py script”.

For this example, we will input a py script like the one shown

in the screen shot to the right.

Procedure

1. From the main menu, enter the Python mode.

This displays the file list screen.•

File names are listed in alphabetical order.•

The values on the right side of the file list indicate the •

number of bytes used by each py file.

2. Create a new file and register a file name*.

Here we will use the procedure below to create a new py file named “OCTA”.

3(NEW)5(A⇔a)j(O)I(C)/(T)v(A)w

This displays the script editor screen.•

* File Names

You can input up to eight letters (eight bytes) for a file name. •

A file name can be made up of single-byte alphanumeric characters (A to Z, a to z, 0 to 9). •

This calculator does not distinguish between uppercase and lower case letters.

Important!

Note that a file with a name that starts with a numeral or a name that is a Python reserved

word will not run.