Installation Guide

ManualsBrandsCascadia ManualsLighting & Ceiling FansMayfly 12.5-in H Burnished Bronze Medium Base (E-26) Outdoor Wall Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0111

150110

Mounting Screw (B)

Wire Nut (E)

Cross Bar (A)

Set Screw(D)

Bulb Type A Max.100W

(not included)

Photocell

Fixture

Back Plate

Hardware Package (included):

Green Grounding

Screw (C)

Turn off the power at fuse or circuit box.

Turn on the power at fuse or circuit box.

Installation Steps

fuse

Green Grounding Screw (C)

Outlet Box

Wire Nut (E)

Set Screw (D)

Cross Bar (A)

Mounting Screw (B)

Fixture Wire

House Grounding Wire

Fixture Grounding Wire

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

1. Attach cross bar to the outlet box by using two mounting screws.

Note: Make sure that the cross bar are lined up horizontally, to ensure that the fixture will be level.

2. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar with the green grounding

screw. Then connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

3. Attach the back plate to the cross bar by locating set screws into “L” slots..

NOTE: With silicone caulking compound, caulk completely around where the back plate meets with the

wall surface to prevent water from seeping into the outlet box.

4.Install bulb (not included) into the socket of the fixture body. See relamping label at socket area or package for

maximum allowed wattage.

“L”Slot

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0111 WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Operation the Unit Without Photocell Photocell Black Wires From Photocell White Wires From Photocell Red Wires From Photocell Wires From Fixture Wires From Main Power Wire Nuts Pigtail Wires From Fixture Wire Nut White Pigtail Fig.1 Fig.2 1. Turn off the power at the fuse or circuit box before starting installation. 2. Loosen the wire nuts connected with the wires from photocell. (See Fig.1) Note: Do not move the photocell to prevent water from seeping into the outlet box. 3.