Installation Guide

CONNECTION OF DRAIN HOSES
STEP ONE
DISHWASHER INSTALLATION
STEP TWO
STEP ONE
6) Affix the condensation strip under the work surface
of cabinet. Please ensure the condensation
strip is flush with edge of work surface.
7) Place the dishwasher into position.(Illustration 4)
8) Level the dishwasher. The rear food can be adjust-
ed from the front of the dishwasher by turning
the Allen screw in the middle of the base of dish-
washer use an Allen key (Illustration 5A). To adjust
the front feet, use a flat screw driver and turn the
front feet until the dishwasher is level (Illustration 5B).
9) The dishwasher must be secured in place. There
are two ways to do this:
A) Normal work surface:Put the installation hook into
the slot of the side plane and secure it to the
work surface with the wood screws (Illustration 6).
Dishwasher must be level for proper dish rack opera-
tion and wash performance.
1) Place a spirit level on door and rack track inside
the tub as shown to check that the
dishwasher is level.
2) level the dishwasher by adjusting the three level-
ling legs individually.
3) When level the dishwasher, please pay attention
not to let the dishwasher tip over.
Insert the drain hose into a drain pipe with a minimum
diameter of 40mm, or let it run into the sink, making
sure to avoid bending or crimping it. The top of the
hose must be less than 1000mm.
The maximum adjustment height of the feet is 50 mm.
1) Install the furniture door to the outer door of the
dishwasher using the brackets provided. Refer
to the template for positioning of the brackets.
2) Adjust the tension of the door springs by using an
Allen key turning in a clockwise motion to
tighten the left and right door springs. Failure to do
this could cause damage to your dishwasher (Illus-
tration 2).
3) Connect the inlet hose to the cold water supply .
4) Connect the drain hose. Refer to diagram.(Fig 6)
5) Connect the power cord.
Page 3
INSTALLATION GUIDE
Built-in Dishwasher