Owner's manual

WIRELESS USB HOST ADAPTER SELECTION

The “HOST” button on the Wireless VGA Device Adapter is used to switch between Wireless USB Host

Adapters. By pressing this button, the Wireless VGA Device Adapter will look for the next associated

Wireless USB host adapter in its list and connect to it. The 1-2-3 lights indicate which host is connected

and will move position based on which host is currently associated. The LED scheme is as follows:

Wireless USB Host Adapter Reset

To erase all Wireless USB host adapters associated to your Wireless VGA Device Adapter, hold down the

“RESET” button for 10 seconds. This will cause the Wireless VGA Device Adapter to erase all Wireless

USB host adapters that have been associated from its list. Each Wireless USB host adapters will then

have to be re-associated with the Wireless VGA Device Adapter using one of the association processes

(cable or pin association) in order to connect to the Wireless VGA Device Adapter again.

ht Li

User 1 On Off Off

User 2 Off On Off

User 3 Off Off On

User 4OnOnOff

User 5 Off On On

User 6 On Off On

USING THE WIRELESS USB TO VGA ADAPTER KIT