User Manual v12.1.0 Instruction Manual

Brocade Network Advisor SAN + IP User Manual 1409

53-1002949-01

GSLB site management

The Site Configuration dialog box allows you to configure a GSLB ServerIron ADX product with site

parameters. A GSLB site contains GSLB ServerIron ADX products that belong to that site.

Click the Site Configuration tab on the GSLB dialog box to view the GSLB sites that have been

defined for the system, and perform one of the following tasks:

• Click Add to create a new GSLB site.

• Select an existing GSLB site, and click Edit if you want to modify it.

• Select an existing GSLB site, and click Duplicate if you want to create a new site by copying an

existing site.

Adding a site configuration

1. Click Add on the Site Configuration tab on the GSLB dialog box.

The Site Configuration dialog box displays, shown in Figure 617.

FIGURE 617 Site Configuration dialog box

2. Enter a name for the site configuration in the Name field and a site name in the Site Name

field.

3. Select the location of the site from the Site Location list.

4. Select the Distributed Health Check check box if you want to enable health checks for all

ServerIron ADX products at this site.

5. Enter the weight assigned to the ServerIron ADX product in the site in the Weight field. GSLB

traffic can be distributed among GSLB sites based on weights configured for the sites. The

weights determine the percentage of traffic each site receives in comparison with other sites,

which may or may not have weights. Weight applies to all the ServerIron ADX products in the

site. The weight can be from 0 through 100. The default is 0. If you want to use this weight,

then do not enter IP weights in the zone configuration.

NOTE

The weight of the ServerIron ADX product displays in the IP Weights list of the Add Hosts dialog

box.