User Manual v12.1.0 Instruction Manual

1126 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Adding an FCIP circuit
27
FIGURE 472 FCIP Circuit Advanced Settings
- Selective the Ack check box to disable selective acknowledgement. This should not be
done unless your system cannot support selective acknowledgement.
- Use the Keep Alive Time Out (ms) option to override the default value of 10000 ms. As
shown, the range is from 500 to 7200000.
- Use the Max. Retransmission Time (ms) option to override the default value of 100 ms.
- Use the Max. Retransmits option to override the default value of 8. As shown, the range is
1 to 8.
- Select L2CoS and DSCP priorities. Refer to “QOS, DSCP, and VLANs” on page 1108 for
more information.
- Select OK to save the settings and close the dialog box.
13. Click Apply on the Add FCIP Circuit dialog box to add the circuit and leave the dialog box open
to add additional circuits. Click OK to add the circuit and close the dialog box.
14. Click OK to close the Add FCIP Tunnel dialog box.
Logical switch function in FCIP Add Circuit dialog box
The display and function of circuits created on logical switches and with shared GbE ports varies in
the FCIP Add Circuit dialog box according default switch and user-configured logical switch
discovery as follows. For details on configuring FCIP with logical switches, refer to the “Using FCIP
with logical switches” section in the Fabric OS FCIP Administrator’s Guide.
• If both the default logical switch and user-configured logical switch are discovered:
- The GigE Port drop list will display all GigE ports in all logical switches, including ports from
default switch and user-configured logical switches.
- A circuit created with a shared GigE port will create an interface on the default logical
switch, but the circuit will be created on the selected logical switch.
- Selecting Verify IP Connectivity verifies the connectivity using default logical switch, since
the interface is on this switch.