ADA Wiring Guide

ManualsBrandsBroan ManualsWall HoodsBroan Glacier 30" 250 CFM 1.5 Sones White Range Wall Hood

99045858ACVR09‐27‐2017









AdditionalInformationfor

RangeHoodsmeetingADACompliance



BroanandNuTonebrandedresidentialrangehoodscanbeinstalledtocomply

withSections308and309ofADAGuidelines,whenusedwithappropriately

mountedcontrolsinstalledat15”to48”abovethefloorandcontrolaccess

shouldnotrequirereachingoveracookingappliance.



ThefollowingrangehoodscanworkinanADACompliantsituationwhenthe

rangehoodiswiredtooperatefromadedicated,standardelectricalwallswitch.

Tofacilitatethisapplication,sharetheinformationonthefollowingpageswith

yourelectricianwhenpreparingfortheinstallation.



THISPROCEDUREAPPLIESTOTHEFOLLOWINGRANGEHOODSERIES



BroanSeries:BCS3,BCSD,BCSEK,BKSA,BKSF,BNSC,BQSEN,BQSJ,CLSC,CRSA

andCRSF



NuToneSeries:AHSA,AVSF,NCS3,NCSEK,NKSAandNQSEN



Summary of content (4 pages)

PAGE 1
Additional Information for Range Hoods meeting ADA Compliance Broan and NuTone branded residential range hoods can be installed to comply with Sections 308 and 309 of ADA Guidelines, when used with appropriately mounted controls installed at 15” to 48” above the floor and control access should not require reaching over a cooking appliance. The following range hoods can work in an ADA Compliant situation when the range hood is wired to operate from a dedicated, standard electrical wall switch.
PAGE 2
ADA HIGH VOLTAGE WIRING INSTRUCTIONS FOR SINGLE BLOWER RANGE HOODS WITH ROCKER SWITCH CONTROL ! WARNING For residential (domestic) installation only. Before proceeding, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.
PAGE 3
CAUTION Use standard switches that are rated 120 VCA, 15 A. Only use wires suitable for at least 90oC (194oF). Ensure the wires are reliably routed away from the halogen lights (if present). According to your needs, there are 2 ways to wire a 2-rocker switch control to these range hoods: 120 VAC power cable entering the range hood or 120 VAC power cable entering the switch box. 120 VAC POWER CABLE ENTERING THE HOOD 2-ROCKER SWITCH Install a 2-rocker switch at a convenient place for the user.
PAGE 4
RED WIRE CONNECTION NOTE: The light switch in rocker switch controls differs from models to others; some light switch have 2 terminals while others have 3 terminals. The illustrations below applies to both light switch models. MOTOR SWITCH TERMINALS LIGHT SWITCH TERMINALS A A Cut the BLACK wire that is connected to motor switch and light switch. BLACK WIRE MOTOR SWITCH TERMINALS LIGHT SWITCH TERMINALS B Cap off the BLACk wire connected to the light switch terminal.