Instruction manual

26
SW : 1.21
DATE : Nov 10 2006
KEY : 1.00
REAR: 1.09
VERSION
an SD card, and then transfer these settings to
any number of MDR-304A recorders.
SAVE: Saves the whole setting to the SD
card.
LOAD: Loads the whole setting from the SD
card.
VERSION:
This item is in the setup menu: it shows the BIOS
version, the software version and last updated
date, and the rear board version.
Alarm and Motion Settings
ACC IGNITION ON:
In this mode a recording can be activated both
manually or automatically according to the auto start
record setting. To activate an alarm recording, set the
auto start record setting to “off” and “ALM
OPERATION” to “ON” in the “ALARM SETTING” page.
When an alarm is triggered, the device will record in
the set alarm-recording rate.
ACC IGNITION OFF:
1. After the ACC is powered off (ACC OFF), the
MDR-304A will record continuously for the time set
in the "POST-REC DURATION" time. If the user
enables both “ALM OPERATION” and the
“MOTION DETECTION” functions the MDR-304A
will not start recording until motion alarm is
triggered during the "POST-REC DURATION"
period. The length of recording will depend on the
Alarm Duration setting.
2. Motion detection can only be activated in the
“ACC OFF” mode..
3. Please take note that if the "POST-REC
DURATION" time is over, the MDR-304A will stop
recording even if the "ALM DURATION" is set for a
longer time period than the "POST-REC
DURATION" time.)
4. With “ACC OFF” any externally triggered alarm will
not influence the recording mode which you set. But
the MDR-304A will calculate the time of the
"POST-REC DURATION" anew in this situation.
5. If the "POST-REC DURATION" time ends while the
“DELAY OFF” time is still active, the MDR-304A will
not start a post-recording or a motion recording, and
the external triggers will have no effect.