Installation Guide

Note: If the appliance is installed in an island unit or

another installation that is not described here, you must

ensure that the cooktop is sufficiently ventilated.

Installation Procedure

9 CAUTION

Sharp edges. Use protective gloves when installing

the cooktop.

Note: The appliance is heavy. It is advisable to install it

with a second person.

Installing the heat shield

9 CAUTION

Sharp edges. Use protective gloves when installing

the plate.

For safety reasons, the heat shield must be properly

installed when closed cabinets are used. This prevents

components from overheating as a result of the

recirculation of hot air from the cooktop.

The heat shield is the same width as the cooktop. For

shipping, it is screwed to the bottom of the burner box.

After unpacking the cooktop, unscrew the heat shield.

The heat shield will be able to rotate freely, as shown in

the illustration.

Secure the cooktop to countertop

9 CAUTION

Do not let the glass drop into place. Make sure that

it is supported along a broad area of the edges

when carefully placing the cooktop into the cutout.

The appliance must be secured from below using the

hold-down brackets provided, so it does not slip.

Note: Protect delicate countertops by placing a wooden

disk underneath.

Rotate the appliance and position it so that the screws

provided are seated loosely in the holes. Move the

hold-down brackets so that the appliance can be

placed in the cutout.

Place the appliance carefully into the cutout.

Insert the clamping screws into the hold-down

brackets and secure the appliance to the countertop.

Tighten screws.