6720808877-00.
| Index Index 1 Key to symbols and safety instructions . . . . . . . . . . 3 1.1 Key to symbols . . . . . . . . . . . . . . . . . . . . . . . 3 1.2 General safety instructions . . . . . . . . . . . . . . 3 2 Product details . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.1 Declaration of Conformity . . . . . . . . . . . . . . 2.2 Type overview . . . . . . . . . . . . . . . . . . . . . . . . 2.3 Included items . . . . . . . . . . . . . . . . . . . . . . . . 2.4 Rating plate . . . . . .
Key to symbols and safety instructions | 3 1 Key to symbols and safety instructions 1.1 Key to symbols Warnings Warnings in this document are identified by a warning triangle printed against a grey background. Keywords at the start of a warning indicate the type and seriousness of the ensuing risk if measures to prevent the risk are not taken. The following keywords are defined and can be used in this document: • NOTICE indicates a situation that could result in damage to property or equipment.
| Product details Regulations All local by-laws and regulations pertaining to installation and use of gas appliances must be observed. This appliance must be installed in accordance with the manufacturers installation instructions, AS/NZS5601, AS/ NZS3500, and all Local Building & Gas fitting regulations. This appliance must not be installed indoors or in an enclosed space. This appliance is approved for outdoor installation only. Do not install this appliance with any modification or alteration.
Product details | 5 2.3 • • • Included items Gas continuous flow water heater Fixing brackets Appliance documentation 2.4 Rating plate The rating plate is located on the outside of the appliance, on the bottom. The particular room has the indications on the performance of the appliance, approval data and the serial number. 2.5 • • • • • • • • • 2.
| Product details 2.7 Appliance layout 1 21 2 12 13 3 14 4 5 6 7 8 15 9 16 17 18 10 19 11 6720808877-03.1V 20 Fig.
Operation instructions | 7 3 Operation instructions 3.2 Open all the water and gas valves. CAUTION: ▶ The initial start-up of the water heater must be done by an authorised installer who will provide the customer with all the information required for the proper operation thereof. CAUTION: Burns! In the flue exit area, high temperatures may be reached. ▶ Do not touch the flue exit area while in operation.
| Operation instructions ▶ Press the buttons and desired temperature. until you reach the The display shows the temperature previously set and this goes on to be the selected temperature. 3.6 Draining the appliance NOTICE: Not draining the appliance when a freezing risk exists may damage components of the appliance. If draining the appliance is required, the following process should be followed: 6720806146-04.1V Fig. 5 Selecting the required temperature, reduces the energy and water consumption.
Maintenance (only by authorised technicians) | 9 4 Maintenance (only by authorised technicians) To guarantee that the consumption of gas and the emission of exhaust gas are maintained at the best values, we recommend that the appliance be inspected every two years and if necessary, maintenance works be carried out. Maintenance must only be performed by an authorised service technician. ▶ Your appliance should only be attended to by a Bosch service technician.
| Troubleshooting 5 Troubleshooting Fitting, maintenance and repair must only be carried out by authorised technicians. The following table describes the possible solutions. Display Description Possible solution A0 Cold and hot water temperature sensor damaged. ▶ Check temperature sensor and associated connections. ▶ If the problem persists, call an authorised service technician.
Troubleshooting | 11 Display Description Possible solution E2 Faulty inlet water temperature sensor. ▶ Check temperature sensor and associated connections. ▶ If the problem persists, call an authorised service technician. E4 Air temperature sensor detects overheating (leaking ▶ Switch off at the power point and remove combustion products inside the combustion the plug from the electrical socket. chamber). ▶ Do not try to Restart the appliance. E9 Activated thermal fuse.
| Environment / disposal 6 Environment / disposal Environmental protection is a fundamental corporate strategy of the Bosch Group. The quality of our products, their efficiency and environmental safety are all of equal importance to us and all environmental protection legislation and regulations are strictly observed. We use the best possible technology and materials for protecting the environment taking into account of economic considerations.
Water quality | 13 7 Water quality All Bosch water heating appliances are constructed from high quality materials and components and all are certified for compliance with relevant parts of Australian and New Zealand gas, electrical and water standards. Whilst Bosch water heaters are warranted against defects, the warranty is conditional upon correct installation and use, in accordance with detailed instructions provided with the heater.
| Warranty details 8 Warranty details Robert Bosch (Australia) Pty Ltd (Bosch) Manufacturer's Warranty (Applicable for purchases from 1 January 2012) All Bosch hot water units are carefully checked, tested and subject to stringent quality controls. 1.
Warranty details | 15 Privacy Act 1988 (Cth). Bosch will not forward customers' personal information to third parties other than for the Purpose. A customer can object at any time to the use of their personal information for the Purpose. Bosch will cease to use a customer's personal information accordingly if an objection is made. 7.
6720813938
