Using the Ducted Gas Central Heating Ducted Evaporative Air Conditioning With your Multi-appliance Slimline Control Owner’s Manual Please keep this important manual in a safe place. It is the owner’s responsibility to ensure that regular maintenance is carried out on this ducted heating / cooling product. Failure to do so will void all guarantees beyond statutory and legal requirements. www.bonaire.com.
Multi-Appliance Slimline Control Contents Introduction Introduction .........................................................................................................4 YOUR SLIMLINE CONTROLLER................................................................................................................4 GENERAL INFORMATION..........................................................................................................................5 Important Installation Notice .........................
Multi-Appliance Slimline Control Contents Introduction Fan Mode ................................................................................................................................ 18 WATER MANAGEMENT ...........................................................................................................................19 Dialflo ...................................................................................................................................... 19 Aquamiser ...............
Multi-Appliance Slimline Control Introduction Introduction Introduction YOUR SLIMLINE CONTROLLER This technologically advanced controller comes with Slimline control for cooling and heating plus many other setup functions. Your Slimline Controller has been designed to operate the following products: Heating – BONAIRE MB - 3, 4, 5 Star Ducted Gas Central Heaters. Fresh Air Conditioners – BONAIRE Ducted Evaporative Air Conditioners.
Multi-Appliance Slimline Control Introduction Introduction GENERAL INFORMATION IMPORTANT INSTALLATION NOTICE A licensed person is required to install Climate Technologies equipment. If the equipment is not installed in accordance with the installation instructions and the governing body regulations, Climate Technologies reserves the right to refuse service on non compliant installations.
Multi-Appliance Slimline Control Navigating the Controls Navigating the Controls SLIMLINE CONTROLLER CONNECTIONS There are two types of Inputs/Outputs connections on Slimline Controller. 1. Digital Communications 2. R & W Connections Digital Communications R&W Connections Digital Communications Digital Communication is connected to the Slimline Controller by a 4 wire cable.
Multi-Appliance Slimline Control Navigating the Controls FEATURES OF THE SLIMLINE CONTROLLER 1. Temperature Sensor: The Slimline Controller has an on board temperature sensor for room temperature measurement. 2. LCD: The LCD shows different information depending on the functions in use. The LCD usually shows only those items relevant to the appliances you have installed. It will display the room temperature (“ROOM”), set temperature (“SET”), timer count and modes of operation (AUTO, MAN, FAN). 3.
Multi-Appliance Slimline Control Navigating the Controls TIMER SETUP If the Slimline Controller is in the OFF state, the delay time displayed will represent the turn ON time. The LED of last Mode selected in the previous ‘ON’ state and ON/OFF LED will flash. If the Slimline Controller is in the ON state, the delay time displayed will represent the turn OFF time. To setup Timer, 1. Press the TIMER button. The Timer LED will come on and the display will show “4H” which indicates a delay time of 4 hours. 2.
Multi-Appliance Slimline Control Navigating the Controls • Fan Mode: In Fan Mode the Fan LED will come on and ‘FAN’ will appear on the display. The user can adjust the Fan speed between 1(Low) and 12(High). NOTE: Fan speed is only available if digital communication loom is installed. Please see your Authorised Bonaire Installer. ERROR REPORTING AND REMOVING ERROR While operating the Slimline Controller, an error will be reported by “Er” on the screen.
Multi-Appliance Slimline Control Ducted Gas Central Heating Ducted Gas Central Heating Owner’s Operation and Maintenance Manual Please keep this important manual in a safe place. It is the owner’s responsibility to ensure that regular maintenance is carried out on this Ducted Gas Central Heater. Failure to do so will void all guarantees beyond statutory and legal requirements. www.climatetechnologies.com.
Multi-Appliance Slimline Control Ducted Gas Central Heating Congratulations on purchasing this BONAIRE ducted gas central heating system, an exciting new product manufactured by Climate Technologies. Wholly designed and manufactured in Australia, this Ducted Gas Central Heater represents an exciting new development in warm air furnace design. It embodies the latest advances in gas heating technology.
Multi-Appliance Slimline Control Ducted Gas Central Heating OPERATING THE SLIMLINE CONTROLLER To operate your Slimline Controller simply press the ON / OFF button. The unit will then display the default or last used settings and will be ready to operate. Any changes made to the Slimline Control settings will have a 3 second delay before the unit responds. If an Evaporative cooler is connected in conjunction with a central heater, you may have to toggle through the modes to select the heating functions.
Multi-Appliance Slimline Control Ducted Gas Central Heating FAN MODE In Fan mode, the fan in the heater can be used to circulate the room air without running the heating. NOTE: Fan speed is only available if digital communication loom is installed. Please see your Authorised Bonaire Installer. To operate the Fan Mode: STEP 1 Turn the Slimline Controller ON by pressing the ON/OFF button. STEP 2 Press the MODE button until ‘FAN’’ appears on the display and the Fan LED will turn on.
Multi-Appliance Slimline Control Ducted Gas Central Heating HEATER MAINTENANCE GENERAL CUSTOMER MAINTENANCE Return Air Grille Filter. If your heating system has a filter in the return air grille, it is extremely important it is cleaned every 3 – 4 weeks during the operating period to ensure correct operation of the heating unit. Failure to do so may cause your heater to stop because of over temperature and cause an unnecessary service call not covered by warranty.
Multi-Appliance Slimline Control Ducted Gas Central Heating PROBLEM SOLVING Central Heater will not operate! 1. 2. 3. 4. 5. Question Y/N Solution Has the unit been run since installation? Yes Refer to question 4 No Check the unit is turned on at the power point and the gas cock is turned on. Call the installer to commission the unit. Yes Refer to question 3 No Refer to question 4 Yes Refer to question 4 No Check the unit is turned on at the power point and the gas cock is turned on.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning Ducted Evaporative Air Conditioning Owners Operating and Maintenance Please keep this important manual in a safe place. It is the owner’s responsibility to ensure that regular maintenance is carried out on this Evaporative Air Conditioner. Failure to do so will void all guarantees beyond statutory and legal requirements. www.climatetechnologies.com.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning INTRODUCTION Your ducted evaporative air conditioner is engineered to meet the rigors of our harsh Australian environment. Operated and maintained in accordance with this manual, it will provide you with years of cool and environmentally friendly operation. Please take the time to read this manual. The principal of your unit is to introduce fresh air, which is washed through the filter pads to provided cool fresh air.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning OPERATING THE SLIMLINE CONTROLLER To operate your Slimline Controller, simply press the ON/OFF button. The unit will then display the default or last used settings and will be ready to operate. Any changes made to the Slimline Controller settings will have a 3 second delay before the unit responds.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning WATER MANAGEMENT DIALFLO BLEED OFF All evaporative air conditioners need some water bleed-off to prevent build-up of mineral deposits in the system. The correct setting of the bleed rate will ultimately govern the life of the unit. With normal town water supply, in good water quality areas, bleed rate should be adjusted so that the discharge is not less than 10 litres per hour subject to unit size.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning DUCTED EVAPORATIVE AIR CONDITIONER MAINTENANCE GENERAL All Ducted Evaporative Air Conditioners require some general maintenance to ensure continued cooling efficiency and a long life. Maintenance is carried out at the beginning and end of summer to start up and close down your unit.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning MOTOR AND FAN Check that the fan spins freely and that there is no build up on the blades. ELECTRICAL No general maintenance is required to the electrical system. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or it’s service agent. A Qualified Electrician should only carry out electrical connections and maintenance.
Multi-Appliance Slimline Control Ducted Evaporative Air Conditioning TROUBLE SHOOTING GUIDE PROBLEM PROBABLE CAUSE Unit fails to start REMEDY A Black – out a Wait b Tripped Circuit Breaker b Reset c Blown Fuse c Replace d Electrical Fault d Call Climate Technologies Service Provider a Pump Seized a Isolate power and then take off top of pump and try to free it. Some lubricant may help.
Multi-Appliance Slimline Control Warranty – Australia Warranty IMPORTANT: Please read this warranty information and complete the Dealer/Product information on the following page. KEEP this with your original purchase documents for any claim under warranty. Firstly refer to your owners manual to ensure you have followed the correct operating procedures of your product, and refer to the trouble shooting guide to assist solving any problems you may have. 1.
Multi-Appliance Slimline Control Warranty – Australia Exclusions to warranty • Consumable items subject to wear and tear such as filter pads drive belts and bearings are not covered by this warranty. • Components used as part of the installation such as grilles filters, ducting, fittings, zone motors and consumer services pipe work are warranted from your place of purchase and not covered by this warranty.
Multi-Appliance Slimline Control Warranty – Australia PERIODS OF WARRANTY – YEARS BY PRODUCT AND APPLICATION: Ducted Gas Heating Unit Components RESIDENTIAL Parts Labour COMMERCIAL Parts Labour Heat Exchanger 10 3 2 2 Burner 10 3 2 2 3 3 1 1 **All other components ** Return air filter/s and zone motors are field supplied and therefore are not covered by the above warranty periods.
Multi-Appliance Slimline Control Warranty – Australia PROOF OF PURCHASE: It is important that the name of the Dealer or Retailer from whom you purchased your product and the name of the installer are recorded on this page. The installer is responsible for the correct installation, start up and demonstrating the operation of this product. The Dealer or retailer is also responsible for issuing the relevant certificates of compliance for the electrical connections.
Multi-Appliance Slimline Control Service - Australia SER VICE SERVICE CENTRES: Only qualified service personnel should conduct any service work carried out on your heating / cooling ducted system. It is important that periodical service is carried out on your product to ensure your will receive the efficiency benefits the product provides. For Metro Service only ring the numbers below. South Australia 1300 665 087 Email: saservice@climtech.com.
Manufactured by Climate Technologies ABN 13 001 418 042 26 Nylex Avenue Salisbury, SA 5108 Australia www.bonaire.com.
