Instructions / Assembly

Log Lighter
GAS VALVE
CSA Certi ed to ANSI Z21.15*CSA 9.1 Standards
• Cast Brass valve with so seat
• For use with natural and LP gases
• Angle valve (911)  ow capacity: 108,000 Btu/hr @ ½ psig
• Straight valve (910) flow capacity: 82,000 Btu/hr @ ½ psig
• Floor plates and matching keys available in Chrome and Brass
TO INSTALL:
1.  e main valve for the supply gas line MUST be in the
closed position.
2. Blow out ALL grit, dirt or other foreign material from the
gas line BEFORE connecting the gas valve to the gas supply
line. Use a gas-rated Te on® tape on all joints.
3. Screw the gas valve onto the threaded gas supply pipe
making sure that the gas valve is in the closed position.
4. Turn on the main supply gas valve and run a pressure test
(½ PSI) on the system before closing the wall or  oor.
Apply soapy water to all joints and look for any bubbles to
signal gas leakage.
5. Do not use excessive torque on the gas valve during
installation.
WARRANTY
All Blue Flame
®
products are warranted for one full year. Canterbury Enterprises
will replace any of its products shown to be defective for a period of twelve (12)
months from the date of purchase. A return authorization is required. The company
assumes no liability for improper installation or operation of its products.
WARNING:  is product can expose you to
chemicals including lead, which are known to the
State of California to cause cancer and birth defects
or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov
!
BLUE FLAME VALVE is designed
to be used with the BLUE FLAME
LOG LIGHTER for Wood Burning
Logs or with Artifi cial/Gas Log Sets.
Canterbury Enterprises
[phone]
Made in China
Master Contract No: 248402
Log Lighter
GAS VALVE
CSA Certi ed to ANSI Z21.15*CSA 9.1 Standards
• Cast Brass valve with so seat
• For use with natural and LP gases
• Angle valve (911)  ow capacity: 108,000 Btu/hr @ ½ psig
• Straight valve (910) flow capacity: 82,000 Btu/hr @ ½ psig
• Floor plates and matching keys available in Chrome and Brass
TO INSTALL:
1.  e main valve for the supply gas line MUST be in the
closed position.
2. Blow out ALL grit, dirt or other foreign material from the
gas line BEFORE connecting the gas valve to the gas supply
line. Use a gas-rated Te on® tape on all joints.
3. Screw the gas valve onto the threaded gas supply pipe
making sure that the gas valve is in the closed position.
4. Turn on the main supply gas valve and run a pressure test
(½ PSI) on the system before closing the wall or  oor.
Apply soapy water to all joints and look for any bubbles to
signal gas leakage.
5. Do not use excessive torque on the gas valve during
installation.
WARRANTY
All Blue Flame
®
products are warranted for one full year. Canterbury Enterprises
will replace any of its products shown to be defective for a period of twelve (12)
months from the date of purchase. A return authorization is required. The company
assumes no liability for improper installation or operation of its products.
WARNING:  is product can expose you to
chemicals including lead, which are known to the
State of California to cause cancer and birth defects
or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov
!
BLUE FLAME VALVE is designed
to be used with the BLUE FLAME
LOG LIGHTER for Wood Burning
Logs or with Artifi cial/Gas Log Sets.
Canterbury Enterprises
[phone]
Made in China
Master Contract No: 248402