Installation Guide

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

01/09/2015

1. Mark spot on wall where Flange will be attached.

2. Un-assemble Flange as shown in picture (A.)

a.) Un-thread “Threaded Sleeve” (1)

b.) Use Allen Wrench (5) provided to detach Ring (2)

c.) Un-thread Escutcheon (3)

3. Attach Mounting Bracket (4) to wall using anchors

and screws provided.

4. Thread Escutcheon (3) onto Mounting Bracket (4)

as shown in picture (B.)

5. Put Threaded Attachment Ring (2) onto Mounting

Bracket (4) and tighten using Allen Wrench (5)

provided as shown in picture (C.)

6. Thread “Threaded Sleeve” (1) onto Attached Ring (2)

as shown in picture (D.)

7. Push shower rod into sleeve-internal O-Ring will hold

rod in place.

8. We recommend use of ceiling supports to stabilize

shower rod.

Parts Included

• 2 Mounting Brackets • 2 Escutcheons •2 Threaded Attachment Rings

• 2 Threaded Sleeves • 4 Wall Screws • 2 Anchors • Allen Wrench

Decorative

Shower Flange

Tools Needed

• Pencil • Drill • Measuring Tape • Screwdriver

350

PAGE 1
Decorative Shower Flange 350 INSTALLATION INSTRUCTIONS Parts Included • 2 Mounting Brackets • 2 Escutcheons •2 Threaded Attachment Rings • 2 Threaded Sleeves • 4 Wall Screws • 2 Anchors • Allen Wrench Tools Needed • Pencil • Drill • Measuring Tape • Screwdriver A. 1. Mark spot on wall where Flange will be attached. 2. Un-assemble Flange as shown in picture (A.) a.) Un-thread “Threaded Sleeve” (1) b.) Use Allen Wrench (5) provided to detach Ring (2) c.) Un-thread Escutcheon (3) 3.